Catalog excerpts
Radio Module PHOENIX-W Wireless M-Bus/ OMS Product Description PHOENIX-W is a low cost wireless RF Module , based on S2 LP and a STM32L051 controller in the frequency range 868MHz and an output power up to +16 dBm . The module offers compact design, has a very low current consumption and is ideally suitable for battery driven applications. PHOENIX-W is also PIN compatible to Maia and is delivered with OMS software stack (OMS 3.x or OMS 4.2 specification). We are ready to support you with the integration of the module into your application and the appropriate antenna design with antenna simulation, development and measurement. The module is suitable for a wide range of metering applications, both on the meter and on the receiver side. Meters can be made OMS- capable in a very short time or gateways can be enabled to receive OMS-capable systems. PHOENIX Pinout Output power: up to +16 dBm 32-bit MCU ARM® Cortex® M0+ Controller MCU frequency up to 32 MHz 64 KB Flash memory, 8KB SRAM, 2KB EEPROM Ultra-low-power Rx= Typ. 7,2 mA Tx= Typ. 20 mA 2,0-3,6 V Antenna pad / u.Fl socket Small footprint (14,5 mm x 13,4 mm) Conforms to RED & CE regulations PHOENIX development board available WEPTECH elektronik GmbH WEPTECH elektronik GmbH reserves the right to make changes to technical specifications or functions of the product without any notice. WEPTECH elektronik GmbH does not assume any responsibility for the use of the described products. All trademarks , registered trademarks and product names are the prop
Open the catalog to page 1All WEPTECH catalogs and technical brochures
-
mioty® Gateway AVA
1 Pages
-
wM-Bus NB1 Gateway SWAN2
1 Pages
-
mioty® radio module COUA
1 Pages
-
Thread & BLE module SPARROW
1 Pages
-
wM-Bus NB1 Gateway SWAN
1 Pages
-
wM-Bus / OMS repeater CRANE
1 Pages