Centre height Swing over cross slide Cross slide travel Cross section of turning tool (height x width) Main drive Drive power at 100 % Max. torque at main spindle Spindle dia. in front bearing Spindle bore Taper in spindle nose Speed range Feed range Longitudinal Tailstock Quill diameter Quill travel Metric threads Inch threads With steady rest max. Cycle-controlled lathes Thread cutting range Workpiece weights Conventional/Servo-conventional lathes Main spindle Distance between centres Number of speeds Electrical equipment DA 210/260 • Brake motor with brake lifting magnet • Working voltage 3 x AC 400 V N / PE / 50 Hz • Control voltage 230 V AC • Contractor control accomodated in a lockable control cabinet • Protection against inadvertent restart in case of voltage failure • Safety switch for L.H./R.H. rotation of main spindle • Emergency stop button at headstock and apron • Lockable main switch • Protection of the main motor by means of temperature sensor • Electric system in accordance with VDE 0100/0113 Radial drilling machines Working range www.weiler.de WEILER Werkzeugmaschinen GmbH Mausdorf 46 • D-91448 Emskirchen Telephone +49 (0)9101-705-0 Fax +49 (0)9101-705-122 [email protected] • [email protected] Cycle-controlled lathes Optional accessories • Three and four jaw chucks • Special working voltages • Machine lighting • Rapid traverse for longitudinal and transverse axes • Two-speed main motor • Digital readout • Insulation for the tropics • Independent four jaw chucks • Back plates • Driver plates with protection rim Technical data Conventional/Servo-conventional Lathes Standard equipment DA • Coolant attachment • Rear splash guard • Multisuisse quick-change toolpost size B incl. 1 toolholder • Chuck guard with limit switch monitoring • Chip deflector • Change gearbox door with limit switch monitoring • Bedstops with micrometer screw • Tailstock quill with twist stop and ejection slot • Taper bush for main spindle MT 4 (DA 210) MT 5 (DA 260) • Male centre MT 4 (DA 210) MT 5 (DA 260) • Grease pump • Set of wrenches • Instruction manual with spare parts list • Machine card • Textured paint NCS Long-term precision and operating convenience Technical variations reserved · 07/0

The advantages of the conventional range are ultimate precision and operating convenience as well as refined technology Standard design Headstock Utmost turning accuracy and rigidity is inherently enabled by the robustly proportioned main spindle and precision bearing. Case-hardened and finely ground gears ensure that running noise is minimized. All gears in the 12 stage transmission run in an oil bath. The hardened spindle head is executed as a short taper with bayonet attachment in accordance with DIN 55027. The forward and reverse movement of the main spindle is switched on and off through...