UNIVERSAL JOINT SERVICE INSTRUCTIONS SNAP RING 1 Remove all snap rings TO DISASSEMBLE UNIVERSAL JOINT EXTERNAL Position joint in loose vice, strike top arm of unsupported yoke to drive the top cup up. Repeat on opposite side. If you cannot grip the loosened cup per Step 3, use a pointed tool to tip a needle bearing then repeat Step 2. Grip loosened cup in vise, strike yoke arm to drive yoke off cup. Repeat on opposite cup. Support cross in loose vise and strike yoke arm. Repeat Step 3 to remove remaining two cups. TO REASSEMBLE UNIVERSAL JOINT N: Smear grease into bearings and check for dirt. Insert cup and cross. Drive in with spacer. Insert snap ring. Insert second cup and hold cross into cup. Drive cup flush with arm. GREASE KIT AFTER ASSEMBLY IS COMPLETED Drive cup down with spacer and insert snap ring. To loosen cross, strike yoke arm and check cross for free rotation. Position second yoke on cross. Repeat Steps 2 to 6. UNCONTROLLED DOCUMENT 56-15134-02 Weasler Engineering, Inc. P.O. Box 558, West Bend, WI 53095 USA Tel: +1-262.338.2161, Fax: +1-262.338.3709 E-mail: [email protected] web site: www.weasler.com Weasler Engineering BV P.O. Box 266, 6600 AG, Wijchen, The Netherlands Tel: +31 (0)24 64 89 100, Fax: +31 (0)24 64 89 109 E-mail: [email protected] web site: www.weasler.com Weasler Engineering Kft P.O. Box 262, H6001, Kecskemet, Hungary Tel: +36 (0)76 500 410, Fax: +36 (0)76 500 415 E-mail: [email protected] web site: www.weasler.co