Content: Order Code Technical Data Profinet Interface Connection Technical Drawing

Absolute encoders – multiturn Standard mechanical multiturn, optical Sendix 5868 / 5888 (shaft / hollow shaft) The multiturn encoders Sendix 5868 and 5888 with PROFINET interface and optical sensor technology are ideal for use in all applications with PROFINET technology. The encoder supports the isochronous (IRT) mode and is therefore ideal for real-time applications. High rotational speed Temperature range High protection level High shaft load capacity Shock / vibration resistant Reverse polarity protection Optical sensor Surface protection salt spray-tested optional • Ideally suited for all...

mechanical multiturn, optical Sendix 5868 / 5888 (shaft / hollow shaft) Mounting accessory for hollow shaft encoders Dimensions in mm [inch] Cylindrical pin, long for flange with spring element (flange type 1 + 2) with fixing thread Connection technology Order no. Cordset, pre-assembled M12 male connector with external thread for port 1 and port 2, 4-pin K4P2M-S-M12-CAT 2 m [6.56'] M12 female connector with coupling nut for power supply, 4-pin K4P2M-S-M12 Mechanical characteristics Resolution singleturn 1 ... 65535 (16 bit), scalable default: 8192 (13 bit) Number of revolutions (multiturn) max....

Standard mechanical multiturn, optical Sendix 5868 / 5888 (shaft / hollow shaft) PROFINET IO General information about PROFINET IO The PROFINET encoder implements the Encoder Profile 4.1. (according to the specification Encoder Version 4.1 Dec 2008”) It permits scaling and preset values, as well as many other additional parameters to be programmed via the PROFINET-Bus. When switching on, all parameters are loaded from an EEPROM, where they were saved previously to protect them against power-failure, or taken over by the controller in the start-up phase. Position, speed and many other states of...

mechanical multiturn, optical Sendix 5868 / 5888 (shaft / hollow shaft) Dimensions shaft version, with removable bus terminal cover Dimensions in mm [inch] Square flange, EH 63.5 [2.5] Flange type 5 and 7

mechanical multiturn, optical Sendix 5868 / 5888 (shaft / hollow shaft) Dimensions hollow shaft version (blind hollow shaft), with removable bus terminal cover Dimensions in mm [inch] Flange with spring element, long Flange type 1 and 2 2 Slot spring element recommendation: cylindrical pin DIN 7, 0 4 [0.16] 2 3 x M3, 5.5 [0.22] deep 2 Recommended torque for the clamping ring 0.6 Nm Flange with stator coupling, 0 63 [2.48] Flange type 5 and 6 2 Recommended torque for the clamping ring 0.6 Nm Flange with stator coupling, 0 65 [2.56] Flange type 3 and 4 2 Recommended torque for the clamping ring...