Series SX200 for direct installation in hydraulic cylinders Key-Features: - Measurement range up to 12 m - Pressure-sealed up to 300 bar - Output signals: SSI, CANopen, Profibus, EtherCAT, Profinet, further on request - Alternative draw wire mechanics for encoder installation - Unpressurised encoder

INTRODUCTION The WayCon SX200 Draw Wire Sensor is designed for an installation directly in the head of a hydraulic cylinder. The sensor reliably determines the exact position of the cylinders piston and emits an equivalent output signal by its sensor element. The draw wire mechanics gets installed in the pressurised area whereas the sensor element (an absolute encoder) is attached at the outside of the cylinder. The SX200 is particularly suitable for long stroke cylinders and telescope cylinders with pressurized oil filled housings. By giving feedback signals to a machine control unit it is possible...

TECHNICAL DATA MECHANICS

TECHNICAL DRAWING detail A Position rope outlet (X) at...

TECHNICAL DRAWING CUT-OUT at least Ø 71 Ø 53 assembly: encoder-coupling clamping flange, ø36 edge free from burrs sharp edges bevelled ACCESSORIES Piston wire fixation clip fixation rope clip hydraulic cylinder housing

Measurement range [m] 8 / 10 / 12 Sensor without encoder Draw wire mechanics 1⁾ Sensor with encoder SSI CANopen Profibus DP EtherCAT Profinet Connection draw wire mechanics F58K connector M23, 12 pins, radial (SSI) cable output, radial, 1 m, PVC (SSI) cable gland, radial (CAN, PRO)2⁾ connector 2 x M12, radial, 5 pins (CAN)2⁾ connector 3 x M12, radial, 5 pins (PRO)2⁾ connect. 3 x M12, radial, 4 pins (CAT, NET)2⁾ 1⁾ for encoder installation Encoder requirements: clamping flange Ø 36 mm shaft length 20 mm shaft diameter Ø 10 mm 2⁾ removable bus terminal cover for fixation of wire rope on piston...