Draw Wire Sensor ZX
3Pages

{{requestButtons}}

Catalog excerpts

Draw Wire Sensor ZX - 1

Content: Technical Data Technical Drawing Electrical Connection Order Code Series ZX Key-Features: - Ultra-compact body - Measurement range 38 mm 2 - Sensor element: potentiometer or hall effect device 3 - Anodized aluminium housing - Wire rope: Nylon jacketed stainless steel - Easy mounting

Open the catalog to page 1
Draw Wire Sensor ZX - 2

TECHNICAL DATA ZX-PA Measurement range Linearity Repeatability depends on the signal quality of the reference voltage 25 (over full range extension) Sensor element Output signal Hall-Effect device 24.8 mV/mm at 1 VDC input voltage Output impedance Input impedance Power supply cable, 3 wires, length 457 mm Protection class Operating temperature Storage temperature Shock resistance Vibration resistance Life cycle Extraction force anodized aluminium Draw wire Nylon jacketed stainless steel, Ø 0.46 mm For nominal output in application, multiply value shown by actual excitation voltage....

Open the catalog to page 2
Draw Wire Sensor ZX - 3

ELECTRICAL CONNECTION ZX-PA, ZX-HM Connection cable ZX-PA +Vin +Vout (Cursor) GND WARNING NOTICES • Don’t let the rope snap back. If the rope is retracted freely, this may lead to injuries (whiplash effect) and the device may be damaged. Caution when unhooking and retracting the rope into the sensor. • Never exceed the specified measurement range when extracting the rope! • Do not try to open the device. The stored energy of the spring drive may lead to injuries when being mishandled. • Do not touch the rope when operating the sensor. • Avoid guiding the rope over edges or corners. Use a...

Open the catalog to page 3

All WayCon Positionsmesstechnik GmbH catalogs and technical brochures

  1. LVIG SERIES

    5 Pages