Colloid Mill For producing, controlled, highly sheared, uniform emulsified products Greater Capacity Waukesha Cherry-Burrell Colloid Mills dispense product inline through larger openings. Clearance setting does not effect product movement. You get up to 50% more flow rate with less heat than other mills. Easy Clearance Adjustment Just set a simple, calibrated ring. It locks in position in increments of .001 between .010 and .240 inches. No special tools. Less chance for error. Less downtime. Clearance adjustment can be made ‘on the fly’ during operation or when stopped. Easy Cleaning With the stator removed, you gain complete visibility. Comes off without tools. Also can be cleaned in place depending on application. Longer bearing & seal life Shaft and bearing position is independent of clearance adjustment, so heavy duty, pre-loaded bearings can be used for longer life. Runs quieter, too. Easy to Disassemble With only seven basic parts to the mill. Cleaning and inspection are quick and easy.

Colloid Mill Dimensions: Waukesha Cherry-Burrell Design Conventional Design A serrated conical stator and serrated rotating cone make up the emulsifying head. Clearances are determined by moving the stator not the shaft. Shaft, bearings and seals are all fixed. Standard mills require the forward or backward movement of the shaft within its bearings to achieve desired clearance settings. Wear on parts affect emulsion results. Tools required. Errors, easy. Simple Stator Adjustment Complicated Shaft Adjustment Longer Shaft Life Longer Bearing Life Longer Seal Life Your local contact: SPX Flow Technology...