Colloid Mill For producing, controlled, highly sheared, uniform emulsified products Easy Cleaning Waukesha Cherry-Burrell Colloid Mills dispense product inline With the stator removed, you gain complete visibility. Stator is easily through larger openings. Clearance setting does not effect removed without tools and can be cleaned in place depending on product movement. You get up to 50% more flow rate with less heat than other mills. Easy Clearance Adjustment Just set a simple, calibrated ring. It locks in position in increments of .001 between .010 and .240 inches (0.254 and 6.096mm). Longer bearing & seal life Shaft and bearing position is independent of clearance adjustment, so heavy duty, pre-loaded bearings can be used for longer life. Runs quieter, too. No special tools. Less chance for error. Less downtime. Clearance adjustment can be made ‘on the fly’ during operation With only seven basic parts to the mill. Cleaning and inspection

PRODUCT DIMENSIONS SEAL FLUSH INLET PIPE NIPPLE SEAL FLUSH PIPE NIPPLE 26.81 (681) AS SHOWN. WITH STATOn ALL THE WAY IN Waukesha Cherry-Burrell Design A serrated conical stator and serrated rotating cone make up the emulsifying head. Clearances are determined by moving the stator not the shaft. Shaft, bearings and seals are all fixed. Simple Stator Adjustment Longer Shaft Life Longer Bearing Life Longer Seal Life Conventional Design Standard mills require the forward or backward movement of the shaft within its bearings to achieve desired clearance settings. Wear on parts affect emulsion results....