Friction Torque Limiters Series 300 (with Coupling Serie 300-05) Service Manual P-2070-WE NR 245

To adjust sliping torques for those limiters, you have to proceed as follow: Sizes 10 to 30: Wind the adjusting nut until tight. Make sure that the discs springs are correctly centered on the locking washer. Use spanner to thighten the adjusting nut until no slip is observed under maximum load conditions. In order to avoid excess slip on machine start-up, it is common practice to turn the adjusting nut a further 60 degrees. Sizes 40 to 60: Wind the adjusting nut until tight against pilot plate. Make sure that the discs springs are correctly centered on the pilot plate. Apply load on the spring...

Warner & Tourco FRICTION T.L with couplings Serie 300-05 Manual Service 245 Page 3/3 KEY: 1 - Torque Limiter 2 - Intermediate Flange 3 - Coupling Flange 4 - Spider 5 - Hur 6 - Screw * 7 - Fixing Screw Fixing Screw 15 * Far serie 300-05, the fixing screws will be tighten to the thigtening torque, indicated in the board here under. And installed with Loctite 270 or equivalence in other trade mark, by the customer.

Warranty Warner Electric LLC warrants that it will repair or replace (whichever it deems advisable) any product manufactured and sold by it which proves to be defective in material or workmanship within a period of one (1) year from the date of original purchase for consumer, commercial or industrial use. This warranty extends only to the original purchaser and is not transferable or assignable without Warner Electric LLC’s prior consent. Warranty service can be obtained in the U.S.A. by returning any defective product, transportation charges prepaid, to the appropriate Warner Electric LLC factory....