VITO VS VM VL
72Pages

VITO oil filter system VITO VS VM VL User Manual - Bedienungsanleitung Manual de instrucciones - Manuale d‘istruzione Manual do usuário - Manuel d‘utilisation - ‫دليل

2. Legal information 3. Preface 4. Safety instructions 8. Storage / cooling time 9. Changing the filter paper 10. Cleaning 11. Trouble shooting 12. Waste disposal 1.1 Product description 1.2 Scope of delivery 4.1 Explanation of symbols 4.2 Safety instructions 4.3 Intended use 5.1 Tilt and vibration protection (only VM & VL) 5.2 Acoustic signal (only VM & VL) 5.3 Overtemperature 6.1 Filtration time 6.2 Active cooling (only VM & VL) 6.3 Checking the factory settings 6.4 Offline programming 6.4.1 Adjusting the filtration time 6.4.2 Turning the acoustic signal on/off 6.5 Online programming...

Power indicator (red LED) Filter indicator (green LED) WiFi indicator (pink LED) (only VL) BT indicator (blue LED) (only VL) Start / Stop button Drip pan Star handles (2 pcs.) Control unit Handle Power cord Pump-filter unit Ventilation slots (only VM & VL) Cable protection Cable holder Control panel foil Type label 1.2 Scope of delivery Control panel foil VL (15) 4 Control panel foil VM & VS (15) 2 VITO oil filter system User manual Short instruction Particle filter (11 pcs.) (one is already inserted) Drip pan 2. Legal information VITO AG Eltastrasse 6 78532 Tuttlingen (Germany) Phone: +49...

Dear VITO customer, Thank you for choosing this product by VITO AG. Please read the manual carefully to familiarize yourself with the handling of your VITO oil filter system to ensure proper use. Your local dealer and our customer service are available to answer your questions and provide support. We are thankful for comments and suggestions concerning the VITO oil filter system and / or user manual. (Please find contact information in chapter 2 Legal information.) We hope that you enjoy your VITO oil filter system for a long time and increase the efficiency in your establishment. With VITO...

5.1 Tilt and vibration protection (only VM & VL) If VITO is placed inclined more than 17°, tilts or vibrates too much due to a defect or incorrect placement, VITO will immediately stops off the filtration. The power indicator (1) and the filter indicator (2) flash and a repeating acoustic signal sounds. 5.2 Acoustic signal (only VM & VL) After the boot-up, a short acoustic signal sounds. VITO is then ready for operation. At the end of each filtration cycle, an acoustic signal sounds for 5 seconds. The acoustic signal can be deactivated (see chapter 6 Getting started). In case of overheating...

6.5 Online programming (only VM & VL) VITO offers the option to set the filtration time, the acoustic signal and the network connection online, using a smartphone, tablet or PC. 1. Plug in the VITO. 2. Open the WiFi settings of your device (tablet, smartphone or PC). 3. Search for the network “VITO Config + Serial number”. The serial number (SN) of the VITO can be found on the type label (16). 4. Connect to the network. 5. Enter password: 12345789. WiFi indicator (3) flashes (only VL). 6. Open the web browser. 7. Enter IP address 10.10.10.10 8. Tap on VITO drop. 9. Log in with: User name:...

Lift VITO out of the drip pan (6). Insert the filter paper into the pump-filter unit (11) (see chapter 9 Changing the filter paper). Close the filter cover. Snap the filter cover into the bottom of the pump-filter unit (11). Place the control unit (8) on the pump-filter unit (11). Make sure that there is no gap between the control unit (8) and the pump-filter unit (11). This indicates that the filter cover has not been closed properly and snapped. Tighten the star handles (7). There must be no gap between the control unit (8) and the pump-filter unit (11). Place the VITO in the deep fryer....

Clean the pump-filter unit (11) every time the filter paper is changed. Clean VITO only when it is cooled down. DO NOT use abrasive cleaners. DO NOT use a wire brush or similar. Make sure that VITO has cooled down. Loosen the star handles (7) (on both sides). Detach the control unit (8) from the pump-filter unit (11). Open the pump-filter unit (11). Remove and dispose of the filter paper (see chapter 12.2 Filter disposal). Manual cleaning or cleaning with the dishwasher Clean the control unit (8) with a damp cloth! DO NOT use running water! This will damage the control unit! Wash the...

EN 11. Trouble shooting Malfunction Possible cause Remedial action Power indicator (red LED) (1) remains inactive Power cord (10) not plugged in Power cord (10) defective Device defective Plug in VITO Please contact service Please contact service VITO is very noisy during operation Star handles (7) are loose Rotor defective Rotor scratches on the fryer Tighten star handles (7) Please contact service Change position of VITO in deep fryer Power indicator (red LED) (1) flashes + acoustic signal (VM & VL) Let VITO cool down Place VITO in a cool place Power indicator (red LED) (1) and filter...

12.3 Device disposal (Take-back concept for b2b waste equipment) All customers of VITO AG may contact us at any time to return waste equipment if required. This usually happens when devices and/or electronic circuit boards are defective or when devices are exchanged for a newer generation of devices. We dismantle the devices accordingly and return the separated raw materials to the environmental cycle. All electronic components are handed over via our disposal points specified at ear® (stiftung elektro-altgeräte register®) and proven via the annual notification to ear®. Send VITO to: VITO...

Issued by VITO AG | Eltastrasse 6 78532 Tuttlingen (Germany) | Phone : +49 (0) 7461 / 96289-0 Fax : +49 (0) 7461 / 96289-12 | Email: info@vito.ag For the product VITO VS, VM & VL: EU Patent No. 1326692 / U.S. Patent No. US7.052.605.B2 The professional oil and fat filtration equipment is manufactured and tested according the following standards: Machinery Directive Electromagnetic Compatibility Low Voltage Directive RoHS - Directive (Restriction of certain Hazardous Substances) Minimum requirements to protect the safety and health of workers WEEE Directive Radio Equipment Directive - EN...