Check Valves CVH0.S09 Valve Series Hybrid SAE Cartridge - 420 bar Technical Data Maximum operating pressure Maximum flow Direct acting - Ball type Cracking pressure Maximum Internal Leakage External component treatment O-ring Temperature Range Cross Section Oil Temperature Range Fluids Viscosities Filtration Orientation Installation torque 420 bar 50 l/min See table below 0,10 cm3 / min @ 10 bar 0,10 cm3 / min @ 420 bar Zn/Fe - standard (96h) Zn/Ni (720h) -30° C to 110° C (standard sealing NBR - BUNA-N) -30° C to 110° C Mineral - based or synthetics with lubricating properties 7,4 to 420 cSt 20/18/15 ISO 4406 (maximum filtration admitted) No restrictions 40-45 Nm Technical Specifications for characterization A screw-in, cartridge style, direct acting, ball type check valve. Main use is as a blocking or load-holding device. The CVH0.S09 allows flow passage Performance Details from port 1 to 2: the cartridge has a fully guided check which is spring-biased plied at port 1 to open to 2. The flow is blocked in the opposite direction (2 to 1). Technical Features All external surfaces are zinc plated and Note: The performance chart illustrates flow handling capacity. p/Q curves are recorded at TOil = 40°C and 46 cSt closed until sufficient pressure is ap- Flow (l/min) Ordering Code corrosion-proof. All valve parts are made of high strength steel. Compact size. Industry common used hybrid cavity Specifications may change without notic