Check Valves CVC0.S10 Valve Series SAE10 Cartridge - 420 bar Technical Data Maximum operating pressure Maximum flow Direct acting - Poppet type Cracking pressure Maximum Internal Leakage External component treatment O-ring Temperature Range Cross Section Oil Temperature Range Fluids Viscosities Filtration Orientation Installation torque 420 bar 80 l/min See table below 0,10 cm3 / min @ 10 bar 0,10 cm3 / min @ 420 bar Zn/Fe - standard (96h) Zn/Ni (720h) -30° C to 110° C (standard sealing NBR - BUNA-N) -30° C to 110° C Mineral - based or synthetics with lubricating properties 7,4 to 420 cSt 20/18/15 ISO 4406 (maximum filtration admitted) No restrictions 55-65 Nm Technical Specifications for characterization A screw-in, cartridge style, direct acting, poppet type check valve. Main use is as a blocking or load-holding device. The CVC0.S10 allows flow passage Performance Details from port 1 to 2: the cartridge has a fully guided check which is spring-biased plied at port 1 to open to 2. The flow is blocked in the opposite direction (2 to 1). Technical Features All external surfaces are zinc plated and Note: The performance chart illustrates flow handling capacity for significant spring bias options. p/Q curves are recorded at TOil = 40°C and 46 cSt closed until sufficient pressure is ap- Ordering Code Flow (l/min) corrosion-proof. All valve parts are made of high strength steel. Poppet is hardened and ground to guarantee minimal wear and to extend service life. Compact size. Optional bias springs for back-pressure application flexibility. Industry common cavity. Specifications may change without notice.