PRELIMINARY DATASHEET Infrared detection module with an integrated differential amplifierFEATURES • Spectral range: 1.7 to 5.9 pm • Single, low-voltage power supply: 3.0 V • Differential output • III-V material • Gas detectors with MEMS, LED, or laser sources • Temperature sensors • Embedded systems • Portable devices The AM03100-02 is a cost-effective infrared detection module designed for high-volume applications. The detection structure is optimized for wavelengths up to 5 pm. The built-in differential amplifier provides high immunity to electromagnetic interference. Wide frequency bandwidth and low 1/f noise corner frequency provide efficient measurements with generally available sources of radiation, including MEMS heaters and pulsed LEDs or lasers. Small dimensions and solderable PCB provide easy mechanical integration with the target device. VIGO Photonics S.A. reserves the right to change these specifications at any time without notification.

AM03100-02 DETECTION MODULE PRELIMINARY DATASHEET \IIGO PHOTONICS CONNECTIVITY AM03100-02 has a form of PCB with 12 solderable pads on the sides of the PCB. The description of pins and pins ordering are shown in TABLE 2, FIGURE 2 and FIGURE 3. FIGURE 2. Pinout of the module connector Do not stress the device above the limits specified in this chapter since it may cause permanent damage to the device. TABLE 1. Absolute maximum ratings The detection module is specified for 3.0 V. For higher supply voltages some DC parameters will change, but the module will still operate properly. VIGO Photonics...

AM03100-02 DETECTION MODULE PRELIMINARY DATASHEET \IIGO PHOTONICS SPECIFICATION+3.0 V supply, Tamb = 20°C, Rioad = 1 MQ to ground, unless otherwise noted. TABLE 3. Module specification Test conditions, remarks Value Unit SPECTRAL CHARACTERISTICS VIGO Photonics S.A. reserves the right to change these specifications at any time without notification.

AM03100-02 DETECTION MODULE PRELIMINARY DATASHEET TYPICAL PERFORMANCE CHARACTERISTICS 400 Responsivity, V/W Voltage noise density, nV/Hz1/2 +3.0 V supply, Tamb = 20ºC, Rload = 1 MΩ to ground, unless otherwise noted. 100 FIGURE 5. Differential output noise density Differential output signal, V Differential output signal, mV FIGURE 4. Spectral characteristic POWER SUPPLY The module can be powered from a single voltage source. A 1 µF capacitor should be placed close to the supply input. Optical power, mW FIGURE 7. Output signal vs input power (i.e. direct connection to differential ADC) it may be...

AM03100-02 DETECTION MODULE PRELIMINARY DATASHEET component on OUTPUT_N. If RsetP and RsetN Rse represent non-zero values, please use thin-film resistors with maximum 0.1% tolerance. For high impedance loads the impact of RsetP and RsetN on the outputs can be calculated using the following formulas: VDC_OUTPUT_P =VCM VDC_OUTPUT_N =VCM + ROFFSET +RsetP WARNINGS The module is sensitive for electrostatic discharge. Special care should be taken to avoid charge flow through the module. Do not touch the detection structure or any electronic components. This may lead to the damage of the module. The...

AM03100-02 DETECTION MODULE PRELIMINARY DATASHEET The AM03100-02 detection modules will be delivered in a panel containing up to 20 individual PCBs (FIGURE 10). Separate the PCBs from the panel before use. FIGURE 10. Dimensions of the AM03100-02 detection module 5x4 panel (given in mm) VIGO Photonics S.A. reserves the right to change these specifications at any time without notification.