Plating Tank Vibrator Catalog
6Pages

VIBRATORS FOR PLATING TANKS IN PRINTED CIRCUIT INDUSTRY We’re The Vibrator Guys.

IDEAS FOR BETTER PLATING WITH VIBRATION • Achieve Better Plating with Proper Vibration • Reduce Rejects VIBCO has designed a special line of electric & pneumatic vibrators for the PC-board industry. A state-of-the-art painting system allows special epoxy paint to withstand acid fumes, paint chipping and rust. Vibco’s continuing research is now investigating plastic and stainless steel models. Over the years many vibrators have been used in the PC-board industry with a high failure rat to the fumes from the bath attacking the vibrator, improperly mounting of the vibrator on tanks and racks...

The SCR-line is speed and force adjustable while in operation. Each unit supplied with a speed dial control. Specify if for 115 volt or 230 volt single phase, standard 50 or 60 cycles, SCR-60CE and SCRW-400CE have O-ring sealed housings for pressure wash down. Model CE-60CE and SPWT-80CE 115 or 230 volt, single phase, 50 or 60 cycles and tions per minute. Units are speed adjustable with standard speed controls, both hie wash down proof. Model 2P - Single or 3-phase operation can be made in any voltage and 50 stant speed units with adjustable eccentrics for adjustable force output. Model BVS...

Model 2P-100CE mounted to electroless copper tanks for catalytic activation. Model 2P-150CE on specially designed mounting bracket. vibration travel only into racks holding PC-boards for greater plate bonding. IT IS POSSIBLE TO COMPLETELY PLATE THE PC-BOARDS WHEN USING VIBCO’S SPECIFIC VIBRATOR TECHNOLOGY AND RECOMMENDED FLIGHT-BAR LOCATOR MOUNTING SYSTEM FOR BEST VIBRATION TRANSFER & AGITATION. Model SPWT-80CE solution tight vibrator assures 100% vibration transfer to PC-boards plating racks. Model 2P-100CE mounted to top of specially designed rack holder. Racks for PC-boards were put into...

APPLICATIONS VIBCO’S APPLICATION ENGINEERS ARE AVAILABLE TO VISIT YOUR PLANT AND HELP TO SOLVE YOUR VIBRATION PROBLEMS. .007” dia. holes in PC-board did not get plated. A SPRT-80CE vibrator placed in the middle of the flight bar locator to agitate the solution solved the problem. SCR-2P-150CE vibrator solved problem plating double sided holes in PC-board Below, when tin plating the boards in the solution air bubbles got trapped in the holes. SCR-100CE vibrator mounted to the flight ball with its shaft vertically to obtain a gyratory motion removed the bubbles. Above, customer was using a...

A series of 2P-150CE vibrators used on robotic plating lines. PLC’s allow vibrators to operate when racks with PC-Boards are put into plating tanks. Model SPRT-80CE on series of single tanks. Model 2P-150CE used on single rack design for rinse cycle after PC-Board drilling. 100% of drill burrs are removed. VIBCO, INC. 75 Stilson Road, PO. Box 8 Wyoming, RI 02 E-Mail: vibr<' Phone: FAX: