Driver, Bit and Screw Cross-Reference

This section provides a detailed cross-reference between driver types, bit sizes, and screw standards, primarily based on Japanese Industrial Standards (JIS) such as JIS B 1180, B 1181, B 1123, among others. It includes precise measurements in millimeters and designations for various socket sizes (e.g., H4, H5.5, H7), as well as Philips, Pozidriv, Supadriv, Hex, Ball point, and TORX bit types.

• Socket sizes are matched with corresponding screw sizes referencing JIS standards.
• Philips, Pozidriv, and Supadriv bits are cross-referenced with JIS B1111, B1122, B1112, B1124, and JCIS 10-70 standards.
• Hex and Ball point bits are listed with sizes and JIS references.
• TORX bit sizes are detailed with references to JIS B 1107, B 1128, B 1136, and JASO F116-89 standards.
• Special notes clarify compliance with old or current JIS standards and specify screw types such as Truss and Whitworth screws.

Technical Data: Air Nipper Cutting Capability

This section details the cutting capacities of various air nipper models and blade types, including horizontal and vertical configurations. Model numbers such as NY03, NY05, NY10, NY15, and NY25 are listed with their respective cutting diameters for materials like soft plastic, hard plastic, copper, steel, and piano wire.

• Cutting capacity varies depending on the model and material type.
• Steel wire is specified as non-heat treated; piano wire hardness is limited to HV320 or below.
• Cutting capability values are indicative and depend on the shape and type of the material being cut.
• Specifications for double action air nippers and blade types are included with capacity data.

Safety Instructions

Comprehensive safety guidelines cover the use of hand tools, bits and sockets, electric tools, air tools, static solutions, and gasoline engine tools.

• Do not use damaged tools (cracked, chipped, worn, deformed).
• Use drivers and bits that properly fit the screw size; avoid using drivers as chisels or levers.
• Wear protective goggles and ear protection during operation.
• Avoid using tools on live electrical circuits or in wet/flammable environments.
• Power tools should never run idly with bits attached; always turn off power before changing bits.
• Gasoline engine tools require specific fuel mixtures and protective gear due to vibration, heat, and exhaust fumes.
• Regular maintenance and inspections are mandatory; do not disassemble equipment.

Reference Index

This section is an extensive alphabetical index of model numbers linked to page references, facilitating quick navigation to detailed specifications and technical data within the broader catalog or manual.

• Model numbers cover a wide range of categories: hand tools, bits & sockets, electric tools, air tools, static solutions, and gasoline engine tools.
• Page references enable efficient lookup of detailed information.

Document Structure and Usage

The document is organized primarily as a navigational tool rather than a technical manual. It groups model numbers alphabetically by prefixes or codes (e.g., AX, AZ, B, BW, C, D, E, F, G, GT, H, HA, IR, JA, KA, KDB, KMD, etc.) with corresponding page numbers for detailed content.

• This index supports locating detailed technical data, specifications, or instructions elsewhere in the full document.
• No direct technical specifications, procedures, or normative standards are included in this excerpt.
• The organization enhances usability for users seeking specific tools or equipment information.

Summary

This document segment serves as a comprehensive reference index for a broad range of tools and equipment models. It is designed to guide users to detailed technical information within a larger catalog or manual. The main sections include cross-references of drivers, bits, and screws; technical data on air nipper cutting capabilities; safety instructions; and an extensive model number index for navigation.