A CMC mill automation system requires robot to CMC integration, vise control, an automatic door, blow-off, and perhaps a gripper. You con spend days putting together a custom solution or you con buy a pre-built, tested, supported, and ready to run solution from Versa Built. Robot2CMC Mill Edition provides bi-directional CMC communication, CMC cycle start and the pneumatic and IO subsystem to implement virtually any CMC automation application. For Universal Robots, the included URCap makes CMC automation programming easy and fast. Select and change CMC programs and cycle-start the CMC from the robot Verify CMC program completes successfully or generates an error Control up to three CMC vises, a robot gripper, pai blow-off, and pneumatic door opener Common interface to all supported CMC controls simplifies programming Included CMC sub-programs allow the CMC to open/close the vises Bi-directional communication between the robot and CMC programs for custom programming Includes URCap to simplify programming with Universal Ro bots ROBINCLUDES Push to connect pneumatic fitings Pneumatic supply valve with lockout provision Ethernet cables + 5-port ethernet switch Serial Interface (Haas Lega cy only) 1 x pneumatic gripper valve (5/3 CE) 3x pneumatic vise valves (5/3 CC) 1 x pneumatic door valve (5/3 CE) 1 x blow-off valve (5/2 NC) to trigger air-piloted high-flow VersaBlast valve * high-flow air-piloted valve sold separately 3x vise sensor inputs 4x door sensor inputs 1 x CMC cycle start relay UNIVERSAL ROBOTS READY v e r s n Contact us for more details [email protected] (208)906-0814 URCap software allows the robot to control the CMC, vises, auto-door, part blow-off and gripper through drag and drop programming.