St*n.d»M Product* System Integration

Introduction: KM6-EC Subracks KM6-EC subracks have been designed and are suitable for high volume, cost sensitive applications. Whilst they are still versatile and fully conform to the requirements of IEC60297, care has been taken to remove certain features found in the KM6-II range to reduce the manufacturing cost. These include lighter extrusion profiles, single-point tiebar fixings (rather than double) and Zintec side plates (rather than aluminium). Lightweight and versatile economy range, supplied in kit form for simple yet accurate assembly EMC conversion options Conductive finish Backplane...

KM6-EC Subracks KM6-EC DIVIDER KITS Use to partially divide 6U into 2 x 3U sections. Please note that divider plate occupies 2HP of front panel space. These kits can be used as right or left hand dividers. COPPER PLATE Full width (2 x 3U) There are two types of 84HP divider kits: SHORT FRONT EXTRUSION Type A contains normal front extrusions, with the ‘eyebrow’ Type B uses a ‘lipless’ extrusion, which will permit the fitting of 6U flat front panels. (EMC panels would require modification to the channel section). LEFT RIGHT Divider plate (Not 84HP versions) 1,2mm aluminium BS 1470 5251H22 (NS4H3)...

The KM6-II covers shown on page 44 of the Handbook can beretrofitted and removed without disturbing the end plates. ∅2.5 HOLES ON STAGGED 4MM GRID A simple ventilated KM6-EC cover is also available. This cover slides between the front and rear extrusion, before fitting the second end plate, to protect the pcb area of EC subracks. The ventilation area is 35%. 1mm perforated mild steel, zinc plate and passivated Ordering information Description Order code SELF ADHESIVE IDENTIFICATION LABELS The extrusions of KM6-EC are unprinted. Where it is required to identify slot positions, self adhesive labels...