Entube SE
2Pages

Entube SE Single Ended - Voltage Sensor The Entube SE series is a family of voltage transducers designed for high quality single ended measurements in a very compact form factor, and without need for power supplies. This series covers the ranges of ±50V to ±2000V with up to 50kHz bandwidth and up to 0.2% of signal accuracy. The Entube-de sensor operates as a differential divider RC-network with an anti-aliasing filter on its output. It generates a ±5V or ±10V scaled down version of the difference between the two input voltages, which can then be processed by a computer based measurement system. The Entube SE is part of Verivolt’s sensing platform, which is aimed at allowing users to laid out multiple distributed sensors with a minimum of cabling required and no power supplies. This platform together with the Entube-de ultra-compact form factor, allows for very high channel densities, while delivering high performance for a low cost. Integrated sensor noise (Referenced to input) Gain (Using 10V standard output voltage) Integrated sensor noise (Referenced to input) Accuracy (percentage of reading) Gain (Using 10V standard output voltage) Max total phase shift at 60Hz Common mode rejection Withstanding differential mode surge voltage Input-Output non-linearity Output voltage Gain temperature drift Differential input dynamic range Signal Layout Common mode rejection Mounting Type Clamp cage Spring cage Power Supply Voltage Output type Output Offset Voltage Outer Dimensions The Entube SE is a voltage divider designed to measure single phases with reference to ground. Input Impedance Line Output Impedance HARDWARE DESCRIPTION Double-ended signal < ± 10µV (on ±10V signal) Environmental Operating temperature Storage temperature The input connect to the sensor via a Spring-cage, while the conditioned signals from the sensor come out on a standard screw terminals. The Entube SE can be mounted anywhere between the signal source and the data acquisition system. A femalescrew on the low voltage side of the sensor allows for DIN rail mounting, and serves as a safety ground. A twisted pair should be used to carry the conditioned signals from the sensor. This will keep good resolution beyond the 10th harmonic on a typical 60Hz system.

MERCHANICAL DIMENSIONS HARDWARE CONFIGURATION A. Safely connect Data Acquistion ground to ground of sensor. B. Securely connect one end of a twisted pair to the output terminals, and the other end to the inputs of your breakout board or data acquisition unit C. Securely connect wire between the source of measurement and an available Entube SE’s input clamp cage. THIS SENSOR IS NOT A SAFETY DEVICE AND IS NOT INTENDED TO BE USED AS A SAFETY DEVICE. This sensor is designed only to detect and read certain data in an electronic manner and perform no use apart from that, specifically no...