ISH10i
4Pages

Catalog excerpts

ADCA HYGIENIC STEAM FILTERS ISH10i DESCRIPTION The ISH10i high efficiency filters are used to remove contaminated particles from gases such as steam and compressed air. The optimized construction of these units offers low differential pressure at high flow rates. All sizes are built in two halves and are joined by a sanitary clamp ferrule according to DIN 32676 Series A. The replaceable filter elements are made of sintered austenitic stainless steel and available with 1, 5 or 25 micron absolute rating. MAIN FEATURES Several retention rates available. Good durability against aggressive gases. Porosity level above 50% to ensure high particle and dirt load capacity as well as good flow rate at a low differential pressure. Regeneration by ultrasonic cleaning. STANDARD SURFACE FINISH Internal wetted parts: ≤ 0,51 µm Ra – SF1. External: ≤ 0,76 µm Ra – SF3. Other surface conditions see TIS.GIA – General information ADCAPure. Ultrasonic cleaning. OPTIONS: Air vent and bottom drain connections. Other connections and dimensions. Vertical installation design (ISV10i). Steam, compressed air and other gases. AVAILABLE MODELS: RETENTION RATES: ASME BPE, DIN and ISO clamp ferrules. Others on request. Horizontal installation with the drain connection pointing downwards. See IMI – Installation and maintenance instructions. CE MARKING – GROUP 2 (PED – European Directive) Ps 16 bar VALSTEAM ADCA We reserve the right to change the design and material of this product without notice.

Open the catalog to page 1

ISFE SIZE ISFE SIZE Remark: Clamp ferrules according to DIN 32676-A (for pipes DIN 11866-A – DIN 11850-2). DIMENSIONS – ISO (mm) SIZE * ISFE SIZE DN 50H 173 560 511 57 78 104 134 77,5 25 * Suffix L corresponds to low capacity design; suffix H corresponds to high capacity design. Remarks: clamp ferrules according to DIN 32676-B (for pipes DIN 11866-B – ISO 1127). Other sizes on request. VALSTEAM ADCA We reserve the right to change the design and material of this product without notice.

Open the catalog to page 2

ADCA LIMITING CONDITIONS * Maximum allowable pressure Maximum allowable temperature Minimum allowable temperature Maximum operating temperature EPM filter element seals EPM filter element seals (steam) Fluoraz filter element seals Minimum operating temperature Maximum cold hydraulic test pressure Maximum differential pressure * Other limits on request. Maximum operating conditions may be limited by the filter housing end connections due to normative restrictions. Remark: maximum recommended pressure drop of 0,07 bar. Filter housing Filter housing cover ** PTFE/FPM Envelope Safety clamp *...

Open the catalog to page 3

ADCA ORDERING CODES – ISH10i FILTER HOUSING Filter model ISH10i – AISI 316L / 1.4404 filter housing Housing seal material PTFE/FPM Pipe connection Clamp ferrule ASME BPE Clamp ferrule ISO (DIN 32676-B) Drain and vent connections Without vent or drain connection With bottom drain connection With bottom drain and vent connection Size 1/4" or DN 08 2"H or DN 50H Special construction / Additional options Full description or additional codes have to be added in case of non-standard combination ORDERING CODES – FILTER ELEMENT Filter element model ISFE – AISI 316L / 1.4404 filter element Filter...

Open the catalog to page 4

ISH10i 4Pages

Catalog excerpts

All VALSTEAM ADCA Engineering S.A. catalogs and technical brochures

ISH10i
4Pages