Level switch GENERAL CHARACTERISTICS The principle of operation of these instruments is based on the drive of one or more magnetic reed contacts, placed inside of the measuring rod, by one or more floats. The only moving element is the float that moves, for buoyancy, along the measuring rod, this guarantees extreme robustness and a limited need for maintenance. Up to 6 switch points. Up to 5 m length depending on the used float. Working pressure up to 6 bars. Operating ambient temperature -30/+55°C UR 90% Standard working temperature up to 130°C. Minimum degree of protection IP65 Built-in temperature sensors, on request. PT – PTC – NTC – Thermostat. Executions (See Multipoint E – Multipoint I series) Material Specific gravity Contact type ELECTRICAL OUTPUT We reserve the right to change the data without notice ELECTRICAL CONTACTS SPST SPST SPDT SPDT C1 – C2 – T1 Cable – Leads Cable L =1,5m Cable L= 3,0m Leads L= 1,0m

PROCESS CONNECTIONS Installation from inside C– P–T output 06 1/8“ Level switch Installation from outside – available thread and flanges Float type All type of floats All type of thread Male thread Available materials ∅ 4,5 mm FVHX - FPHX - FFHX - FSHX Separately wired contacts Common wired contacts Contacts wired on customer request Contacts status in no level conditions A Flanged connection A1 Threaded connection SWITCH POINTS The switch points L1 ÷ L6 are measured from the stop of the fitting or flange connection. General tolerances on switch points ± 3 mm. Minimum distance in mm. F20 Contact...