8 or 20 m3/h pump 0.6 litre resin trap Standard paper cup catchpot Vacmobile E1 – mini-trap series, using standard paper drinking cups for catchpots The Vacmobile E1 series is based on a compacted down form of the resin trap from our well proven 20/2 machine. The compact trap uses a standard paper drinking cup as the replaceable resin catchpot. The paper cups supplied with the machine have a resin catching capacity of 600 ml (20 fluid ounces), with similar size cups being available in most countries. The primary uses of the E1 series are the manufacture of small laminates using resin infusion or moderate sized laminates made by vacuum bagging over wet laminate or pre-preg. The maximum laminate size that can be infused by an E1 series machine very much depends on the experience of the laminator, especially familiarity with the use of wide peel ply resin breaks around the perimeter of the laminate. (For further information on wide peel ply resin breaks, please see our website note “Peel ply resin breaks” (http://www.vacmobiles.com/peel_ply_resin_breaks.html). As supplied from the factory, an E1 series system is not mobile, but it can easily be added to a customer supplied mobile cart if bench top mounting is not appropriate. E1 system (shown with 20 m3/h pump) 650 ml (20 fluid oz) paper cup catchpot Trap lid options Steel lid for vacuum bagging

Vacmobile E1 series Specifications Vacuum pump 1 of the following single phase powered continuous duty oil sealed vacuum pumps: Agilent EM 8/B. 50 Hz capacity 8.5 m³/h (5 cfm). Note that the main benefit of this pump is the low noise level of 58 dB(A) compared with about 66 dB(A) for the 20 m3/h capacity pump. VSV-20. 50 Hz capacity 20 m3/h (11.8 cfm). 60 Hz capacity 24 m3/h (14.1 cfm) Vacuum level Adjustable from 20% vacuum (800 mbar absolute) to the pump’s maximum vacuum: 20 mbar, 2000 Pa, 15 Torr, 98% vacuum*, 29.3“ Hg*, -99.3 kPa*, -14.4 psig* 0.5 mbar, 50 Pa, 0.38 Torr, 99.95% vacuum*, 29.9“...