PC5

PC5

PC5

Product catalog summary
Overview: The PC5 is a compact RS-422 cable driver board designed to drive long cables up to 1000 feet using differential signaling, enhancing noise immunity. It is compatible with E2, E3, H1, H3, S1, and S2 encoders and features a 5-pin socket for easy connection.
Specifications:
  • Output Connector: 10-pin latching connector with Broadcom/Avago compatible pinout.
  • Cable Recommendations: Ribbon cables for up to 100 feet; twisted pair cables for longer distances.
  • Terminating Resistor: Optional 120-ohm resistor for impedance matching on the receiver side.
  • Power Requirements: Consider current consumption by the module, driver IC, and terminating resistors. Ensure sufficient voltage to account for voltage drop.
  • Receiver Chip Recommendation: Use a 0.1uF ceramic monolithic bypass capacitor with RS-422 receiver chips like 26C32.
Features:
  • Avago/HP HEDL compatible output.
Environmental and Mechanical:
  • Operating Temperature: -40 to 100°C.
  • Electrostatic Discharge: -2 to 2 kV (Human Body Model).
Electrical Parameters:
  • Supply Voltage: 4.5 to 5.5 Volts.
  • Supply Current: 1 to 2 mA (26C31).
  • Output High Voltage: Minimum 2.5 Volts (IOH = -20 mA).
  • Output Low Voltage: Maximum 0.8 Volts (IOL = 20 mA).
  • Propagation Time: Up to 15 ns.
Connectors:
  • Driver Header Connector: PC5-H10 TE# 103309-1.
Pin-outs:
  • Pin 1: No connection
  • Pin 2: +5VDC power
  • Pin 3: Ground
  • Pin 4: No connection
  • Pin 5: A- channel
  • Pin 6: A+ channel
  • Pin 7: B- channel
  • Pin 8: B+ channel
  • Pin 9: Index-
  • Pin 10: Index+
Ordering Information: Cables and connectors are not included and must be ordered separately. US Digital® provides a two-year warranty against defects in materials and workmanship.
See more

Catalog excerpts

PC5-1

HP Compatible Incremental Encoder Cable Driver Page 1 of 3 Features ► Avago / HP HEDL compatible output The PC5 is a small, plug-in RS-422 cable driver board that drives long cables up to 1000 feet using differential signalling to provide improved noise immunity. The PC5 can be used with the E2, E3, H1, H3, S1 and S2 encoders. Each board has a 5-pin socket designed to plug into the 5 pins of the encoder. The output side of the PC5 is a 10 pin latching connector with a Broadcom/Avago compatible pinout (HEDL series). On the output side of the PC5, ribbon cables can be used for lengths up to 100 feet; twisted pair cables are recommended for longer lengths. An optional 120 Q terminating resistor may be placed across each pair on the receiver side of the cable, matching the cable's characteristic impedance. When calculating the power requirements of the encoder side of the cable, include the current consumed by the module, the driver IC and any terminating resistors. Be sure to supply sufficient voltage to compensate for the voltage drop due to the resistance of the power and ground wires. If an RS-422 receiver chip such as 26C32 is used on the receiver side of the cable, a 0.1uF ceramic monolithic bypass capacitor across +5V and ground located within 1 inch of the receiver chip is recommended. Mechanical Drawing 0 Environmental USE= 1400 NE 136th Avenue [email protected] Local: 360.260.2468 DIGITAL Vancouver, Washington 98684, USA www.usdigital.com Toll-free: 800.736.0194

 Open the catalog to page 1
PC5-2

HP Compatible Incremental Encoder Cable Driver Parameter Min. Max. Units Electrostatic Discharge, Human Body Model -2 2 kV Mechanical The cable drivers shown below are compatible only with the E2, E3, H1, H3, S1 and S2. PC5 Differential cable driver board. (shown mounted on an S1 encoder). Parameter Min. Typ. Max. Units Notes Output High Voltage 2.5 - - Volts IOH = -20 mA Product Driver Header Connector Mates With PC5-H10 TE# 103309-1 CON-C10* * US Digital part number. For more information see the Cables / Connectors page....

 Open the catalog to page 2
PC5-3

_____ USS= DPC HP Compatible Incremental Encoder Cable Driver DIGITAL r Page 3 of 3 Som7?iaTT7 PC5-H10 Broadcom / Avago Compatible Output ^ Ordering Information PC5 -Connector Notes H10 = ► Cables and connectors are not included and must be ordered separately. ► US Digital® warrants its products against d efects in materials and workmanship for two years. See complete warranty for details. DIGITAL Vancouver, Washington 98684, USA www.usdigital.com Toll-free: 800.736.0194

 Open the catalog to page 3

All US Digital catalogs and technical brochures

  1. AD2B

    3  Pages

  2. A2T

    5  Pages

  3. T7

    9  Pages

  4. USB4

    8  Pages

  5. S6

    5  Pages

  6. S2

    4  Pages

  7. EM2

    7  Pages

  8. E3

    7  Pages

  9. MAE3

    8  Pages

  10. MA3

    5  Pages

  11. HD25A

    5  Pages

  12. A2

    6  Pages

  13. A2K

    7  Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.