USE= CA-CM-PS-CFTR DIGITAL CAN-Bus PUR Shielded Cable with Terminating Resistor, Page 1 of 1 Description Straight CAN-Bus connector connected to a CAN-Bus right angle connector with a built-in terminating resistor in a PUR (polyurethane) shielded cable. The 120 ohm terminating resistor is connected across pin 4 and pin 5. This cable should be employed at the end of a run of cable, to terminate and connect to the last CAN device; only one of these cables should be used in any given CAN network topology. A CA-CM-PS-CFR cable (without terminating resistor) should be used for the intermediate sections of the daisy-chain CAN-Bus network. The cable may also be used with the RS232 and RS485 versions of the T7. Notes ► US Digital warrants its products against defects in materials and workmanship for two years. See complete warranty for details. DIGITAL Vancouver, Washington 98684, USA www.usdigital.com Toll-free:800.736.0194