Pneumatic power clamps UNIVERSAL series The handling, positioning as well as the maintenance operations have to be carried out by observing all conditions which guarantee the security of the staff and only by authorized personnel.The residual risks regarding the sole maintenance phase consist in the squashing of the upper parts of the operator's body between the clamping arm and the shims mounted under the arm. As a preventive measure an appropriate signalling or an adequate security system placed near the dangerous areas and which have to be installed by the user will alert the operator. > Opening angle adjustment 1. Set the clamping arm in the open position and supply the sensor 2. Slide the cover to access the angle adjustment 3. Insert the hex key until it has engaged with the screw 4. Keep the key pushed in its site and rotate it clockwisely to increase the opening angle or counter clockwisely to reduce the opening angle Tighten moderately the fixing screws; then tighten completely the corresponding pairs of screws, one on the right and the other on the left Fixing bosses^ Do not insert the dowels in the clamping arm when it is The fixing of the unit to the equipment can be carried out by using the front, rear or side part of the housing of the clamp. I Fixing to the front or rear surface Insert two hardened and grinded pins into the special seats such as to locate the clamp to the tooling:

- Fix it steadily by using the indicated screws, limiting the tightening torque: ■ Fixing to the side part of the housing of the clamp - Insert two hardened and grinded pins into the special seats such as to locate the clamp to the tooling: -Fix it steadily by using the indicated screws, limiting the tightening torque: > Instructions for the connection of the clamp to its energy source Connect the sensor of the clamp to its electric supply unit. Then connect the pneumatic tube by means of suitable pneumatic fittings according to the specification below: Operating pressure from 4 to 8 bar ELECTRIC...