The Unitronics UCR-B8 enable Unitronics PLC products to communicate via mobile networks (4G). Highlights: 1. 3 Ethernet LAN ports and 1 WAN (configurable can act as LAN) 3. Wireless LAN access point or client to existing network. 4. Embedded send / receive SMS messages directly from UniStream PLCs. 5. RS232, RS485 and USB interfaces with embedded Serial-To-Ethernet functionality. Note: UniLoaic SMS embedded support from Ver. 1.29 and above. 1 Pull the SIM needle out of the router 2 Push the SIM holder button with the SIM needle 4 Insert your SIM card into the SIM holder 5 Slide the SIM holder back into the router

Front View

Ethernet Port LEDs All 5 LEDs are lit up after pressing and holding the reset button to initiate a factory reset.

Power Connector Network termination- Place 120Q termination resistor at each end of the network

D-type 9 pin female connector:

Power Connector Use the Din Rail bracket or M3 screws to mount the device.

Technical Specifications Power voltage range Power consumption Power over Ethernet (passive) Passive PoE over spare pairs. Possibility to power up through LAN1 port, not compatible with IEEE802.3af and 802.3at standards Status LEDs 1 x bi-color connection status 5 x connection strength 4 x LAN status 1x Power 3 x Digital Inputs 1 Analog Input 1 Relay, 24V, 4A, SPST 2 x Digital Open Collector Output 1 x 4 pin DC, 4 x Ethernet 2 x Mobile SMA 2 x WiFi RP-SMA 1 x GPS SMA 1 x RS232 1 x 6 pin RS485 1 x 10 pin I/O USB 2.0 4G (LTE) – Cat 4 DL up to 150 Mbps, UL up to 50 Mbps; DCHSPA+; UMTS; TD-SCDMA;...