Input type Galvanic isolation Nominal input voltage Input voltage pnp (source) Input current Response time Input cable length High speed inputs Resolution Frequency Minimum pulse width Specifications below apply when wired as HSC/Shaft-encoder. See Notes 4 & 5.

2. All products comprise I0-I5; these inputs are arranged in a single group. Via wiring, the entire group may be set to either pnp or npn. 3. Only JZ20-R16/JZ20-J-R16 and JZ20-J-R16HS comprises I6 & I7. These may be wired as either digital or analog inputs, as shown in the JZ20-R16/JZ20-J-R16 and JZ20-J-R16HS Micro PLC Installation guide. I6 & I7 may be wired as npn, pnp, or 0-10V analog inputs. 1 input may be wired as pnp, while the other is wired as analog. If 1 input is wired as npn, the other may not be wired as analog. • I0 and I1 can each function as either a high-speed counter or as a...

Illumination backlight LED, yellow-green, software controlled (LCD backlight; enables the display to be viewed in the dark) Display size 2 lines, 16 characters long Character size 5x8 matrix, 2.95x5.55mm Number of keys Key type Slides Ladder code memory Execution time Memory bits (coils) Memory integers (registers), MODBUS Baud rate USB Port type Galvanic isolation Specification Baud rate range Cable 16 keys, including 10 user-labeled keys Metal dome, sealed membrane switch Slides may be installed in the operating panel faceplate to custom-label the keys and logo picture. An extra logo slide...

6. The JZ20 built-in USB port may be used for programming. Add-on Modules are available by separate order for communication and cloning. Note that the USB port and an Add-on module cannot be physically connected at the same time 7. Add-on module JZ-PRG, with 6-wires communication cable (supplied in PRG kit - see the JZ-PRG Installation Guide) can be used: 8. Add-on module JZ-RS4 (RS232/485), with a standard 4-wire communication cable can be used: - to communicate with other devices (including modems/GSM) 9. Add-on module MJ20-ET1 enables communication over 100 Mbit/s TCP/IP network: - Programming/data...