POP-LOCK Workshop „hose retention system" and Pop-Lock Kit for mobile application. Hose assemblies must be designed in such a way that in case of failure, hazards caused by whipping of the hose assembly can be avoided with suitable protective measures. UNIFLEX offers with the POP-LOCK Workshop „hose retention system'' a solution that meets the requirements of various standards and regulations. The system is designed so that it can be used in three sizes for all common nominal diameters and different lengths. The Pop-Lock system offers special advantages for mobile use, it is easy to install, easily recognizable by the color differences. Can be installed even without disassembling the already installed hose assembly and easy assembled with standard tools. Steel cable coil 50 meters Base cage 100 pieces Marking-, Bending Machines, Nipple Inserter, Pin Prick, Skiving Machines Special rivet 100 pieces Protective rubber hose POP-Lock Refill-Kit 1500.1019 for POP-LOCK DN5-12 (50 sets) Component assembling overview Steel cable Special rivet Ready-to-Go KIT POP-LOCK KIT 03-500 POP-LOCK KIT 04-750 POP-LOCK KIT 05-1000 Include: Steel cable crimped on both sides with sleeves, 2x Protective rubber hose, 2x base cage and 2x rivet Base cage Protective rubber hose Other advantages: • Stainless steel • UV resistant, as completely metallic • Secured against slipping by a blind rivet Tools POP-LOCK Tool-Kit 1500.1022 777.918 Wire rope cutter (1 piece) 777.902 Single hook (1 piece) 777.903 Double hook (2 pieces) 778.007 Cut protection gloves