Plastic Modular Belt Type M2 50% Straight running belt Nominal pitch: 25.4 mm (1.00 in) Surface type: Flat Surface opening: 50% Backflex radius: 30.0 mm (1.20 in) Pin diameter: 5 mm (0.20 in) Belt material & color Non standard material and color: See uni Material and Color Overview. Alternative pin and lock materials: Permissible tensile force (Belt/pin material) Belt width Belt weight (Belt/pin material) *Min. No. drive sprocket per shaft Number of wear strips (Min. No.) **Carry (pcs) Additional standard belt widths are available in steps of 76.1 mm (3.00 in). Additional non-standard belt widths are available in steps of 12.7 mm (0.50 in). Additional standard belt widths are available in steps of 76.1 mm (3.00 in). Additional non-standard belt widths are available in steps of 12.7 mm (0.50 in). General belt tolerance is +0/-0.4% at 23°C/73°F and 50% RH. For exact belt width contact Customer Service. Non standard belt width on request. Belt widths in PA66 is 0.2 % wider than the belt widths in the table above. *Max. Load per Drive Sprocket. Belt material: PP 1100 N (247 lbf); PA66 1400 N (315 lbf). **Max. Spacing between wear strips, Carry: 152 mm (6 in); Return: 304 mm (12 in). = Single Link STRAIGHT RUNNING

Belt material & color Rubber material & color Non Standard material and color: See uni Material and Color Overview. Accessories Flight Running direction Front side: Flat Back side: Non Stick Flight Material & color Flights on 25.4 mm (1 in) are cut down from 50.8 mm (2 in). Link size

Accessories Rollers NON STANDARD A Photo will be updated Roller material & color POM-D Non Standard material and color: See uni Material and Color Overview. Accessories Non Standard uni AmFlight Running direction Other Non Standard option: See uni AmFlight Overview. Principle sketch

Pilot Bore Bore size Overall diameter Molded sprocket Non standard material and color: See uni Material and Color Overview. Molded sprocket Other sprocket sizes are available upon request. Two-part sprocket are available upon request. Round bores are always delivered with keyway. Other bore sizes are available upon request. uni Retainer Rings: See uni Retainer Ring data sheet. Width of tooth = 6.0 mm (0.24 in) Width of sprocket = 25.0 mm (0.98 in) Max load per sprocket shown does not take bore size into account. Please also ensure that sufficient size shaft is chosen for corresponding load. Fabrication...