Plastic Modular Belt Type Straight running belt Nominal pitch: 25.4 mm (1.00 in) Surface type: Y Pattern surface grid Surface opening: 0% Backflex radius: 25.0 mm (0.98 in) P in diameter: 4.0 mm (0.16 in) Recommended transfer roller diameters: ø60 mm (2.36 in). Belt material & color POM SLF orange or yellow links can be used as SAFE WALK markers. *Only for K200 Permissible tensile force (Belt/pin material) POM SLF/PA6.6 Belt width Belt weight (Belt/pin material) POM SLF/PA6.6 Min No drive sprocket per shaft * Number of wear strips (min no) Carry (pcs) Standard Increments in belt width: 76.3 mm (3.00 in). Standard Increments in belt width: 76.3 mm (3.00 in). General belt tolerance is +0/-0.4% at 23°C/73°F and 50% RH. For exact belt width contact Customer Service. Non standard belt width on request. *Max. Load per Drive Sprocket. Belt material: POM-SLF 2300 N (517 lbf). **Max. Spacing between wear strips, Carry: 152 mm (6 in); Return: 304 mm (12 in). ***Full Carry way Support (FS) deck of wearstrip material recommended for safe walk belts. = Single Link STRAIGHT RUNNING

Overall diameter Pilot bore Bore size Moulded sprocket Moulded sprocket Non standard material and color: See uni Material and Color Overview. Moulded sprocket Same sprocket type as for the uni QNB serie. Other sprocket sizes are available upon request. Two-part sprockets are available upon request. Round bores are always delivered with keyway. Other bore sizes are available upon request. uni Retainer Rings: See uni Retainer Ring data sheet. Width of tooth = 10.0 mm (0.39 in) Width of sprocket = 25.0 mm (0.98 in) Max load per sprocket shown does not take bore size into account. Please also ensure...