Plastic Modular Belt C Straight Running Belt Nominal pitch: 8.0 mm (0.32 in) Surface type: Flat Surface opening: Closed Backflex radius: R6 mm (0.24 in) Pin diameter: 3.0 mm (0.12 in) Belt material & color Non standard material and color: See uni Material and Color Overview. Permissible tensile force (Belt/pin material) Belt weight (Belt/pin material) Belt width Min No drive sprocket per shaft Number of wear strips (min no) STRAIGHT RUNNING Additional standard belt widths are available in steps of 76.2 mm (3.00 in). Additional non-standard belt widths are available in steps of 25.4 mm (1.00 in). Additional standard belt widths are available in steps of 76.2 mm (3.00 in). Additional non-standard belt widths are available in steps of 25.4 mm (1.00 in). General belt tolerance is +0/-0.4% at 23°C/73°F and 50% RH. For exact belt width contact Customer Service. Non standard belt width on request. *Max. Load per Drive Sprocket. Belt material: POM-D 200N (44 lbf). **Max. Spacing between wear strips, Carry: 102 mm (4 in); Return: 203 mm (8 in). = Single Link

Overall diameter Pilot bore Bore size Pitch diameter Non standard material and color: See uni Material and Color Overview. Machined sprocket Machined sprocket Other sprocket sizes are available upon request. Round bores are always delivered with keyway. Other bore sizes are available upon request. uni Retainer Rings: See uni Retainer Ring data sheet. Width of tooth = 9.0 mm (0.35 in) Width of sprocket = 25.0 mm (0.98 in) Max load per sprocket shown does not take bore size into account. Please also ensure that sufficient size shaft is chosen for corresponding load. Fabrication & service Transmission...