PROPORTIONAL FLOW CONTROL SOLENOID VALVE (Normally Close) Uflow Automation Ankur Industrial Complex, Survey No: 275/276, Plot No: 31, Nr. Intol Cast Pvt. Ltd. Shapar (Veraval) 360 024. Dist: Rajkot Gujarat (INDIA). Phone No: +91 2827 254343 | Cell: +91 89059 07070 Email: [email protected] | Website: www.uflowvalve.com
Open the catalog to page 1Proportional flow control valve, integral to the design of an inspiratory flow system, provides precision control for the flow of gas. Specialized proportional valves are available for application in ventilators and anesthesia machines and provide accurate and safe delivery of precise gases to patients. APPLICATIONS Ventilators Anesthesia Delivery & Monitors Pressure and Flow Control FEATURES Low power consumption generates less heat Proven performance tested to 100 million life cycles Uses either DC current or pulse width modulation with closed loop feedback to deliver optimal system performance....
Open the catalog to page 2BODY BASIC VALVE DIMENSIONS ELECTRICAL REQUIREMENTS Nominal Supply Voltage (VDC) Nominal Coil Resistance (Ohms) @ 20°C Control Current at Maximum Flow (mA) BASIC CONTROL: proportional valve can be controlled by either voltage or current; however, it is highly recommended that current control be employed to ensure the most repeatable valve flow performance. SUGGESTED PWM CONTROL: For PWM control, the signal applied to the valve should have a frequency of 5 kHz or greater. Optimal frequency will be application dependent. Valve Solenoid Valve Supply Voltage BODY BASIC VALVE DIMENSIONS OPAMP Supply...
Open the catalog to page 3MANIFOLD DIMENSIONS (MM) NOTE: In order to provide the best possible solution for your application, please provide the following requirements when contacting Applications Engineering: Media, Inlet & Outlet Pressures System Supply Voltage Minimum Required Flow Rate Media & Ambient Temperature Range PROPORTIONAL FLOW CONTROL VALVE MODEL IDENTIFICATION CHART I PRESSURE & ORIFICE SEAL MATERIAL PORT TYPE BODY MATERIAL PORT SIZE MANIFOLD MOUNTING Note: Above mentioned pressure is a differential pressure. IBV19M PROPORTIONAL FLOW CONTROL VALVE 60PSI / 5.0 MM ORIFICE MINIFOLD MOUNTING BRASS BODY (5MM)...
Open the catalog to page 4104 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
3 Pages
2 Pages
24 Pages
28 Pages
4 Pages
4 Pages
4 Pages
2 Pages
3 Pages
3 Pages
3 Pages
2 Pages
5 Pages
3 Pages
3 Pages
3 Pages
3 Pages
3 Pages
4 Pages
4 Pages
3 Pages
4 Pages
3 Pages
3 Pages
2 Pages