DHC Noise Isolating Headphones UWC Ultrasonic Wave Form Concentrator RAS/RAM Remote Access Sensor There are two models. Both meet or exceed ANSI specifications and OSHA standards with over 23 dB of noise attenuation. DHC-2 has a headband loop to keep the phones over the ears while DHC-2HH is for Hard Hat use. The DHC-2HH is standard equipment for Ultraprobe® models except the model 100. More than double the detection distance of standard scanning modules with this extre-mely sensitive and directional parabolic dish. The UWC utilizes seven transducers to provide pinpoint accuracy with a 5° reception field. Detection Range: 34 bar (5 psi) through 0.127 mm (0.008”) orifice at distance of 30.48 m (100 ft). When accessibility is an issue such as when a motor is contained within a closed cabinet, or a test point is in a hard-toreach area, the RAS/RAM is an answer. Mount the RAS Sen­ or on the s test point and run a cable to an access area where the RAM (Remote Access Module) can be placed. When the point is to be tested, plug the RAM into your Ultraprobe and view or data log the information. LRM Long Range Module A uniquely designed parabolic microphone that lets you detect leaks and electrical discharges at a distance. The LRM doubles the detection distanceof standard scanning modules. Ultraprobe® 550, 2000: LRM-2 Ultraprobe® 3000: LRM-3 Ultraprobe® 9000 & 10,000: LRM-9/10 HTS Holster Carry your Ultraprobe® on your belt, hands free. Be sure to order the correct holster for your Ultraprobe® model. Ultraprobe® 100: HTS-1 Ultraprobe® 201: HTS-201 Ultraprobe® 550, 2000, 9000: HTS-2 Ultraprobe® 3000: HTS-3 Ultraprobe® 10,000: HTS-10 CFM The Close Focus Module Enhances leak detection of low level leaks and negative pressure (vacuum) leaks. Designed for close up scanning. The receiving chamber focuses all low level acoustic energy straight to the transducer with little loss of energy. Ultraprobe® 550, 2000: CFM-2 Ultraprobe® 9000 & 10,000: CFM-9/10

UE EXC Shielded Cable Plug one end into an Ultraprobe® and plug one of the interchangeable modules into the other end to extend your reach. Standard length is 2.4 m (8"). RAS-MT Uses a magnetic mountable transducer with a cable that is plugged into an Ultraprobe®, which is put on a test point. Ideal for bearing inspections and hard to reach test points. Ultraprobe® 550: RAS-MT-2 (+RAM) Ultraprobe® 2000: RAS-MT-2 (+RAM) Ultraprobe® 3000: RAS-MT-3 (+RAM) Ultraprobe® 9000: RAS-MT-9 (+RAM) Ultraprobe® 10,000: RAS-MT-10 (+RAM) WTG2SP Pipe Threaded Warble Tone Generator 1” NPT male threaded nipple...