Catalogs >
A. u. K. Müller >
Series 42.010.000

Series 42.010.000
4Pages

Catalog excerpts

Pressure Reducer Solenoid valves Control valves Special valves and systems A.u.K. Muller GmbH & Co. KG Dresdener Str. 162 D-40595 Dusseldorf/Germany Tel.: +49(0)211-7391-0 e-mail: info@akmueller.de Internet: www.akmueller.de ■ outlet pressure adjustable, factory presettable ■ balancing of inlet pressure ■ suitable for hot water up to 90°C ■ ambient temperature up to 70°C reduced noise of flow ■ compact design ■ design in allusion to EN 1567 ■ long term performance capability by the use of high quality materials The pressure regulator converts variable inlet pressure into a lower, constant outlet pressure. It can be used to protect equipment from high or inconsistent incoming medium pressure. This reduced and constant outlet pressure also enables a constant flow rate to be achieved independently of the incoming pressure. The orifice used to maintain this constant flow rate should be placed immediately after the pressure reducer. The pressure can easily be adjusted within the regulators specification range and is ideal for applications that require a constant flow rate or a specific timed volume delivery. To ensure operation and long reliability of the pressure regulator it is recommended that a dirt strainer is fitted to the inlet. Check valves or solenoid valves can be placed downstream of the regulator. pressure reducing flow rate regulation ■ protection of pressure caused damages of pipework downstream © copyright A.u.K. Muller, technical changes reserved

Open the catalog to page 1

Pressure Reducer aterials Valve body ptions Material E1915 © copyright A.u.K. Muller, technical changes reserved 2

Open the catalog to page 2

Product Information Pressure Reducer Outlet pressure adjustment Please make sure that the pressure regulator is not bended during installation: Please support connections properly Please align connections properly Outlet pressure adjustment Cap Release screw in middle of the cap Unlock the cap by pulling Set the desired output pressure by turning the cap Press back cap into the locking position Tighten again the screw in the cap middle slightly Upon delivery, the outlet pressure is factory set at 3 bar. Custom presets are available on request. © copyright A.u.K. Müller, technical changes...

Open the catalog to page 3

Open the catalog to page 4

Series 42.010.000 4Pages

Catalog excerpts

All A. u. K. Müller catalogs and technical brochures

Series 42.010.000
4Pages