servo-controlled normally closed (NC) solenoid replaceable while medium circuit remains untouched, solenoid rotatable 4x90° (4 and 5) suitable for hot water up to 90 °C similar performance for AC or DC types long term performance capability optimized water hammer characteristic by low noise emission according to EN 60730 high operating safety by the use of high quality materials and 100% final testing of the products The manifold valve is equipped with two separate inlets (4 and 5) of nominal diameter DN 13. Both provide the main outlet 1. Thus, the user has the possibility to change between warm or cold medium, for example. Flow regulators can be installed in both inlets. Two other valve components of nominal diameter DN 10 (2 or 3) offer additional flow paths. A flow regulator or an orifice can be applied into the valve seats to achieve a defined flow limitation. The valve components are servo controlled and normally closed (NC). Coil systems for common voltage frequency ranges are available. industrial appliances air conditioning agricultural implements pollution equipment dish washers washing machines typical performance curve Electrical operating safety is achieved by insulation class F and can be supported by an integrated protective circuit. By using high quality insulation materials, continuous duty (100 % ED) at higher medium temperatures is possible. Protection against corrosion of inner parts exposed to the medium is achieved by using stainless steel. © copyright A.u.K. Müller, technical changes reserved

manifold valve servo controlled Fitting position any, preferably with coil upwardly cold and heated potable water and physically and chemically similar media Flow regulator Pressure surge Coil type manifold valve other voltages on request Voltage tolerance +10% -15% Duty cycle Nominal power Protection type Valve body Plunger guide stainless steel Coil connections flat tabs 6,3 x 0,8 mm plug socket according to EN 175301-803 (IP65), several cable connections (IP67, IP68) stainless steel Insulation class EPDM NBR (on request) VMQ (on request) Coil coating PBT,PET or epoxy resin POM (in inlet) stainless...