servo-controlled normally closed (NC) solenoid replaceable while medium circuitry remains untouched suitable for hot water up to 90 °C similar performance for alternating- or direct current long term performance capability optimized water hammer characteristic by low noise emission according to EN 60730 high operating safety by the use of high quality materials and 100% final testing of the products steam appliances dental appliances hot / cold drink dispensers industrial appliances air conditioning agricultural implements pollution equipment temperature equalisers dish washers ice machines washing machines water treatment 2/2-way solenoid valve of nominal diameter DN 21 for use with cold and heated potable water and physically and chemically similar media. The valve is servo-controlled and normally closed (NC). Valves of this design are single chamber straight valves with female thread at in- and outlet in different dimensions. Coil systems for common voltage frequency ranges are available. and typical performance curve Electrical operating safety is achieved by insulation class F and can be supported by an integrated protective circuit. By using high quality insulation materials, continuous duty (100 % ED) at higher medium temperatures is possible. Protection against corrosion of inner parts exposed to the medium is achieved by using stainless steel. p / bar © copyright A.u.K. Müller, technical changes reserved

Fitting position any, preferably with coil upwardly cold and heated potable water and physically and chemically similar media Pressure surge 2/2-way single chamber straight valve, servo-controlled Coil type solenoid valve other voltages on request Voltage tolerance +10% -15% Duty cycle Nominal power Protection Type Coil connections flat tabs 6,3 x 0,8 mm plug socket according to EN 175301-803 (IP65), several cable connections (IP67, IP68) Valve body Plunger guide stainless steel stainless steel Coil coating PBT,PET or epoxy resin Insulation class according to EN 60730 according to EN 60730 (for...