Product Information Servo-controlled solenoid valve NC, DN 10 A.u.K. Müller Solenoid valves Control valves Special valves and systems A. u. K. Müller GmbH & Co. KG Dresdener Str. 162 D-40595 Düsseldorf/Germany e-mail: [email protected] Internet: www.akmueller.de Characteristics servo-controlled normally closed (NC) solenoid replaceable while medium circuit remains untouched, solenoid rotatable 4x90° suitable for hot water up to 90 °C similar performance for alternating or direct current long term performance capability optimized water hammer characteristic by low noise emission according to EN 60730 high operating safety by the use of high quality materials and 100% final testing of the products Description 2/2-way solenoid valve of nominal diameter DN 10 for use with cold and heated potable water and physically and chemically similar media. The valve is servo-controlled and normally closed (NC). Valves of this design are single chamber straight valves and can be manufactured with various connections. Coil systems for common voltage and frequency ranges are available. steam appliances dental appliances hot / cold drink dispensers industrial appliances air conditioning agricultural implements pollution equipment temperature equalisers dish washers ice machines washing machines water treatment Electrical operating safety is achieved by insulation class F and can be supported by an integrated protective circuit. typical performance curve 70 60 50 By using high quality insulation materials, continuous duty (100 % ED) at higher medium temperatures is possible. The glass fibre reinforced polyamide valve body persists hot water. Protection against corrosion of inner parts exposed to the medium is achieved by using stainless steel. © copyright A.u.K. Müller, technical changes reserved

Product Information Servo-controlled solenoid valve NC, DN 10 Technical Data Type Fitting position any, preferably with coil upwardly cold and heated potable water and physically and chemically similar media Flow regulator Pressure surge Coil type 2/2-way single chamber straight valve, servo-controlled solenoid valve 1) Fixing possibility for self tapping screw Ø 4,2 2) Fixing groove other voltages on request Voltage tolerance +10% -15% Materials Valve body Duty cycle Plunger guide stainless steel EPDM NBR (on request) VMQ (on request) Coil coating PBT,PET or epoxy resin stainless steel (in inlet)...

Product Information Servo-controlled solenoid valve NC, DN 10 1) 1) Fixing possibility for self tapping screw Ø 4,2 2) Fixing groove Options Material clip possible) * Only for John Guest cartridge Ø 15,0 mm **John Guest cartridge in valve body © copyright A.u.K. Müller, technical changes reserved