Catalogs >
A. u. K. Müller >
01.007.115 Servo-controlled solenoid valve, DN 7

01.007.115 Servo-controlled solenoid valve, DN 7
2Pages

Catalog excerpts

01.007.115 Servo-controlled solenoid valve, DN 7 - 1

Product Information Servo-controlled solenoid valve NC, DN 7 A. u. K. Müller Solenoid valves Control valves Special valves and systems A. u. K. Müller GmbH & Co. KG Dresdener Str. 162 D-40595 Düsseldorf/Germany e-mail: info@akmueller.de Internet: www.akmueller.de Characteristics Servo-controlled Normally closed (NC) Solenoid replaceable while medium circuit remains untouched, solenoid rotatable 4x90° Suitable for hot water up to 90 °C Similar performance for alternating or direct current Long term performance capability Optimized water hammer characteristic by low noise emission according to EN 60730 High operating safety by the use of high quality materials and 100% final testing of the products 2/2-way solenoid valve of nominal diameter DN  for use with cold and heated potable 7 water as well as physically and chemically similar media. The valve is servo-controlled and normally closed (NC). Valves of this design are single chamber valves with the inlet ninety degrees to the outlet. Coil systems for common voltage frequency ranges are available. typical performance curve ∆p / psi Electrical operating safety is achieved by insulation class F and can be supported by an integrated protective circuit. By using high quality insulation materials, continuous duty (100 % ED) at higher medium temperatures is possible. The glass fibre reinforced polyamide valve body persists hot water. Protection against corrosion of inner parts exposed to the medium is achieved by using stainless steel. Steam appliances Dental appliances Hot / cold drink dispensers Industrial appliances Air conditioning Agricultural implements Pollution equipment Temperature equalisers Dish washers Ice machines Washing machines Water treatment

Open the catalog to page 1

01.007.115 Servo-controlled solenoid valve, DN 7 - 2

Product Information Servo-controlled solenoid valve NC, DN 7 Technical Data Type Flow regulator Pressure surge Coil type Materials PA 66 glass fibre reinforced stainless steel stainless steel EPDM Filter (inlet) Coil coating cold and heated potable water and physically and chemically similar media Plunger guide any, preferably with coil upwardly Valve body Fitting position 2/2-way single chamber, inlet ninety degree to outlet, servo-controlled solenoid valve other voltages on request Voltage tolerance +10% -15% Duty cycle Nominal power PBT,PET or epoxy resin Protection Type stainless...

Open the catalog to page 2