Integrated Pin Joint Encoder Series TBA 37 design for rough applications in cranes and agricultural machines Available interfaces are: CANopen Safety with SIL2 (see datasheet: TBN 13080) forward assembly - Robust stainless steel housing. This encoder can be integrated inside the "Pin Joint" of heavy machinery equipment. The mounting is straightforward. This encoder is completely integrated in the joint and avoids external parts. E - lectronic circuit with ASICs, Hall elements and interface electronics in one encapsulated chamber - The analog interface is realized using a 12-bit D/A converter - Electrical connections via cable with open ends (optional with super seal plug). TWK-ELEKTRONIK GmbH Heinrichstrasse 85

Date: 24.07.2014 Page 2 of 7 Document no. TBA 13064 DE CW = Increasing (CCW=Decreasing) signal when looking at the shaft while the shaft is turning right. These values apply at maximum shaft load. Higher va

Integrated Pin Joint Encoder Series TBA 37 Electrical connector Block diagram Interpolator Controller / Sensor

Standard Measuring range The standard setting is adjusted to 360° (characteristic curve). Characteristic curve: Measuring range 360° (Output B) 20 mA 4 mA 0° 360° Electrical connection ■ Cabel with open ends (optional with super seal plug) Connector arrangement Date: 24.07.2014 Page 4 of 7 Document no. TBA 13064 DE

Order number TBA 37 M S 360 W K B 01 Electrical and / or mechanical variants* 01 Standard Output signal: B 4 - 20 mA Electrical connection: K Cable 1 m Signal sense W CW C CCW (optional) Measuring range: 360° Measuring range Housing material: S Stainless steel Flange: M Mounting flange Design form: 37 mm 0 Flange diameter Model: TBA TBA * The basic versions according to the data sheet bear the number 01. Deviations are identified with a variant number and are documented in the factory. Date: 24.07.2014 Page 5 of 7 Document no. TBA 13064 DE

Integrated Pin Joint Encoder Series TBA 37 Installation drawing Order number: TBA 37 - MS 360 W K B01 Dimensions in mm Tube made of 1.4301 (with PUR-potting) Braided shield removed with bevel 2. 2.2x45° Screened PUR-cable Li12YD11Y-5x2x0,34 mm² Color coat: black Cable diameter: ca.6 mm Journal bearing Grommet made of Neopren Shaft sealing ring Installation situation of the sensor with arm in the "Pin Joint" Spiral pin Seeger-Ring J38, DIN472 O-Ring 25x2,5 NBR Arm Pin Joint Encoder TBX 37

Integrated Pin Joint Encoder Series TBA 37 Installation drawing Dimensions in mm Possible interpretation of the customer's Pin Joint for installation of the TBX 37 Drill hole for the spiral pin Mounting accessories Mounting accessories: Spiral pin Seeger-Ring Screws O-Ring Mounting tool 2 x DIN EN ISO 8750, phosphatized and oiled (optional VA) 1 x J38, DIN 472, phosphatized and oiled (optional VA) 2 x DIN 7991-M5x8 1 x O-Ring 25x2,5 NBR 1 x MW-01-A01 Spiral pin 3x16, DIN EN ISO 8750 Mounting tool MW-01-A01 The mounting tool is used to press the spiral pin into the drill holes until the mountig...