Master control Parameters counted from recipe Ramp Line Extruder speed • Central Control Interface for Extruder Ctrl • Layer Ratio: Visualize & adjust set point % of each layer (Max 3) • Stop, start, ramp each individual & all extruders together • Auto / manual control functionality • Visualize current throughput of each layer • Visualize status of each unit on line (OK or in Alarm) • Set & Visualize current running recipe on each gravimetric

- 512 MB onboard flash drive. - analog resistive touch screen, - landscape format, anthracite gray pinstripe. - 2x Ethernet 10/100 Mbit/s (integrated switch), - embedded service page,

• 256 MByte DDR3 RAM, 32 kByte FRAM, • 1 GByte Flash Drive on board, • 1 Ethernet port 10/100 Base-T