Actuator Type 1, 180° - Technical Data, Summary WireMatic actuators are pneumatic quarter turn actuators based on double rack and pinion design. The Type 1 actuator is also available in half turn execution (180°). The Type 1 180° actuator is generally recommended for use with three way valves. Data for Type 1 actuators with movement 0 - 180° This type of actuator is only available as Double Acting (DA) and according to Metric standard Material, standard (outside) • Anodized Aluminum, Silver Movement • 0° to 180° End Stop Adjustment Single End Stop Adjustment, Open position, located in the End Cap Over travel • Open: 3° • Closed: 0° to 0.5° Sizes • 4, 8, 12, 20 and 35 Torque Linear torque, the same rack power over the entire movement Torque Output at 5.5 bar/80 psi • 41 to 375Nm • 363 to 3319in.lbs Operating Pressure • 2-10 bar / 29-145 psi WireMatic TruTorq AB Krossgatan 22 B SE-162 50 Vallingby Sweden

Actuator Type 1, 180° - Technical Data, Summary Drive Medium • Standard: Air (Dry or Lubricated) or inert gases (non-dangerous fluids) • Options (require rebuilding): Hydraulic Oil or Water Temperature Range, Standard execution (Buna Nitrile, NBR O-seals) • - 30° to + 80°C • - 22° to + 175°F Temperature Range, High temperature (Viton O-seals) • - 20° to + 140°C • - 4° to + 284°F Temperature Range, Low temperature • -45° to +60°C • -49° to +140°F Temperature Range, Arctic temperature • -50° to +60°C • -58° to +140°F Stroke Looking at the front of the Actuator, Port A is on the left side and Port...