Trio Motion Technology's range of digital and analogue input/output expansion modules are designed to enable simple and scalable and low-cost I/O extension for Trio's Motion Coordinators. In addition to 24V input, output and bi-directional modules, there are relay and analogue I/O CANbus is used for communication and control between the Motion Coordinator and the CAN 10 m odules. CANbus is a tried and tested, well known data link in industry which is reliable, noise immune and flexible. All CAN 10 modules are compatible with any Motion Coordinator that has a CANbus port. The Motion Coordinator I/O expansion system uses CANbus to reduce wiring and allow input/output modules to be distributed remotely. Up to 16 Digital I/O and up to 4 Analogue I/O modules may be added to the system. No bus connectors are required thus reducing the initial cost of adding I/O. The MC464 has additional capability in that it can handle up to 16 Digital Input modules and 16 Digital Output modules, a total of 32 Digital modules and 4 Analogue modules. The CAN 16 I/O module counts as one Input AND one Output module. As well as being able to connect to any Motion Coordinator using Trio's own high speed CANbus protocol, each CAN module can run the DS401 CANopen protocol. Protocol selection is by DIP switches on the front of the module. The Trio CAN 16 Output module provides up to 256 distributed output channels at Output Capacity Network Speed The Trio CAN 16 Input module provides up to 256 distributed input channels at 24Vdc The Trio CAN 16 Input/ Output module provides up to 256 distributed bi-directional Output Capacity Network Speed Network Speed input/output channels

135mm 35mm I/O Modules CAN 8-IN / 4-OUT ANALOGUE: P326 CAN 8-relay out: P327 The CAN Analogue I/O module provides up to 32 analogue input and 16 output channels per system. The Trio CAN 8 Relay module provides 128 distributed low power relay channels per Motion Coordinator. Inputs 8 x ± 10V inputs with isolation from CANbus Outputs 8 relays 30Vdc / 120Vac Outputs 4 x 0 - 10V outputs with isolation from CANbus Configuration 4 x NO+NC contacts and 4 NO only contacts Network Speed 500KBit/s Network Speed 500KBit/s Protocols TrioCAN IO / CANopen DS401 Protocols TrioCAN IO / CANopen DS401 Compliance...