DUO 500. Dual Mounting System Installation instructions. Official Partner

Mounting 1 •Fasten the ring nuts (1) on the tractor-disc. • Make sure you have used the right tightening torque. • Fasten the ring nuts as close to the rim as possible. Max angle of inclination is 7 degrees. Max angle of inclination is 7 degrees 2 • Fasten the dual hook bar (3) with the big clamp (2). • Fasten the M20 nut (4) at the end of the dual hook bar. • Make sure the tractor wheel is slightl

4 • Mount the dual wheel. Make sure the drum is in the correct position, in level with the tractor-rim. • Put the hook (3) in the ring nut (1) and the big clamp (2) on the clamping ring. Adjust the M20 nut (4) to correct position when the big clamp is open. • Use enclosed clamping tool (6) to lock the big clamp. • Make sure all dual hook bars are firmly tightened. • When the big clamp is open, cut off excessive length of the dual hook bar 20 mm from the M20 nut.

Product specification 1. Ring nut, 4 different sizes are available. M16x1,5 - M16x2,0 - M18x1,5 and M22x70 1 2. Big Clamp 3. Dual hook bar, available in two different lengths, 1000 mm and 1300 mm 4. Nut M20 • Tip over and crushing hazard! • Don’t forget the locking pin! • Always be cautious when handling heavy wheels! • Maximum speed 30 km/h Trelleborg Wheels Systems Nordic AB Hjärtlandavägen 17, SE-576 33 Sävsjö, Sweden Phone: +46038267680