*mydirectindustry

ABS ESD

Product catalog summary

Disclaimer: The document provides information in good faith but disclaims responsibility for any processing of finished articles, packaging materials, and other products. Treedfilaments does not guarantee the information or product described and disclaims all implied warranties, including quality, merchantability, and fitness for a particular purpose.

Suggested Print Settings: The recommended settings for printing with ABS ESD include an extruder temperature of 240-260°C, a plate temperature of 90°C, a minimum nozzle diameter of 0.2 mm, a fan speed of 0-20%, and a print speed of 30-60 mm/s. These settings are internal recommendations and may vary based on specific printer requirements.

Material Properties:

Physical: Specific gravity is 1.10 g/cm³ (ISO 1183).
Mechanical (at 23°C / 50% RH): Young's modulus is 2140 MPa, tensile stress is 30 MPa, strain at break is 22%, and Charpy notched impact strength is 9 kJ/m² (ISO 527, ISO 180).
Thermal: Melting point is 128°C (ISO 11357), and heat deflection temperature (H.D.T.) is 88°C (ISO 75-2).
Electrical: Surface resistivity is greater than 1.00 x 10⁶ Ohm/sq (IEC 167).

Additional Information: ABS ESD filaments can be processed on conventional 3D printers using FDM/FFF technology. For optimal results, pre-dry the filaments at 70°C for 2 hours, increasing drying time for spools up to 1 kg. Avoid leaving the filament in the nozzle for more than 20 minutes; if necessary, reduce the temperature below 210°C and stop thermal control.

Catalog excerpts

Data Sheet SUGGESTED PRINT SETS (1) Suggested print sets test method extruder temp plate temp Young modulus Tensile stress Melting point min. nozzle diameter fan print speed PROPERTY Physical Speciﬁc gravity Charpy notched impact strength Electrical Surface resistivity Disclaimer The above information is provide in good fact .Treedﬁlaments is not responsable for any processing which may occur to product ﬁnished articles , packaging materials and other . Further Treedﬁlaments makes no warranty or representation of any kind regarding the information given or the product described and expressly disclaims all implied warranties , representations and conditions , including without limitation all warranties and conditions of quality , merchantability and suitability or ﬁtness for particular purpo

Open the catalog to page 1

Data Sheet ADDITIONAL INFORMATIONS In General ﬁlaments made with ABS ESD can be processed on conventional 3D printer using FDM / FFF technology. ABS ESD is a special ABS developed for 3D printing and to obtain best results we recommend pre drying the ﬁlaments at 70° for 2 h. Increase drying time for spools up 1 kg. Don’t leave the ﬁlament stopped inside the nozzle more than 20 min. If that down the temperature under 210°, better stop the thermal control. (1) Suggested print set merely represent a recommendation for general use . Every printer necessity a speciﬁc set , nozzle temp, bed temp, etc...

Open the catalog to page 2

ABS ESD

ABS ESD

Catalog excerpts

All TreedFilaments catalogs and technical brochures