Vision on quality www.tqc.eu yJ POWDERTAG THICKNESS ANALYSING GAUGE LD5850 The PowderTAG is a photo-thermal gauge which measures film thickness non-contact and non-destructive. It complies with standard: DIN EN 15042-2. The small and robust device is suitable for fast and precise coating thickness measurement of powder coatings on metallic substrates before and after cure. PowderTAG Thickness Analysing Gauge is extremely versatile. It measures on any form, shape and dimension, on any metal substrate and in almost any angle. The measurement system consists of a sensor and a display device. The sensor is connected via a cable to the display device. DIN EN 15042-2 Consult the appropriate standard for a correct execution of the test. APPLICATION PowderTAG is a non-contact production tool, developed for use at the paint-line. Because the PowderTAG's pulse does not need to be perpendicular, and has a small measuring spot, the PowderTAG is very suitable to accurately determine the layer thickness on small, curved or hard to reach objects. Even on wire frames or small corners and edges. A LED pointer assists in determining the correct distance and location. Due to the non-contact measuring principle parts can be tested on a slow moving line without damaging the coating. For higher line speeds it is recommended to remove the part of the line via a bypass or stop the line.. TQCB.V. 2908 LL Capelleaan den IJssel phone: +31 (0)10-7900100 e-mail: [email protected]

Vision on quality www.tqc.eu SCOPE OF SUPPLY The PowderTAG is delivered in a rugged hard carrying case The package includes: • A photothermal coating thickness sensor with cable • A display unit for displaying the coating thickness readings • Four Li-Ion batteries plus extra pack of four Li-Ion batteries • Quad Charger for Li-Ion batteries • Rubber harness to protect the display unit • Verification tool • Manual ORDERING INFORMATION LD5850 PowderTAG Thickness Analysing Gauge LD5852 Distance-cap (simplifies measurements of cured coatings) LD5851 Height adjustable stand pro LD5853...

Vision on quality www.tqc.eu Point the probe at the surface at the right distance. LED-Pointers will indicate the correct distance / location. When the three LED pointers merge into one spot the distance and location are correct. Then press the "measure" button. SPECIAL CARE • Though robust in design, this instrument is precision-machined. Never drop it or knock it over • Always clean the instrument after use. • Clean the instrument using a soft dry cloth. Never clean the instrument by any mechanical means such as a wire brush or abrasive paper. This may cause, just like the use of aggressive...

SAFETY PRECAUTIONS • This product causes IR radiation. Don't stare into the light source for a long period when in use. • Not suitable to be put in the sun or in the high light • Avoid using it in over-high or over-low temperature environment • Avoid humidity • Always make sure the instrument's power is turned off while adjusting any electric component DISCLAIMER The right of technical modifications is reserved. The information given in this sheet is not intended to be exhaustive and any person using the product for any purpose other than that specifically recommended in this sheet without first...