文件資料管制 文件資料管制 文件資料管制 All rights reserved Main Feature Active PFC Circuit Full Range Input

文件資料管制 文件資料管制 文件資料管制 All rights reserved Description First Edition

文件資料管制 文件資料管制 文件資料管制 All rights reserved 1. GENERAL DESCRIPTION AND SCOPE This is the specification of Model FSP220-50FGBBI/ FSP220-50FGBBI(M); AC-line powered switching power supply with active PFC (Power Factor Correction) circuit, meet EN61000-3-2 and with Full Range Input features. Designed and manufactured by FSP GROUP. The specification below is intended to describe as detailedly as possible the functions and performance of the subject power supply. Any comment or additional requirements to this specification from our customers will be highly appreciated and treated as a new target for...

4.1.3. HOLD-UP TIME @80% LOAD (10% TO 90% OF FINAL OUTPUT VALUE, @FULL LOAD) 115V-rms or230V-rms +5Vdc : 20ms Maximum

4.2. OUTPUT TRANSIENT LOAD RESPONSE The output voltages shall remain wthin the limits specified in 4.1.1 output rating table in page 4 for the step loading and within the limits specified in Table 1 for the capacitive loading. The load transient repetition rate shall be tested between 50Hz and 5 kHz at duty cycles ranging from 10%-90%. The load transient repetition rate is only a test specification. The step load may occur anywhere within the MIN load to the MAX load shown in Table 1. Table 1: Transient Load Reguirements

The power supply will be compliant with each item in this specification for the following Environmental conditions. The subject power supply will withstand the following imposed conditions without experiencing non-recoverable failure or deviation from specified output characteristics. Vibration Operation, 0.01g2/Hz at 5 Hz sloping to 0.02g2/Hz at 20 Hz, and maintaining 0.02g2/Hz from 20 Hz to 500 Hz. The area under the PSD curve is 3.13gRMS. The duration shall be 20 minutes per axis for all three axes on all samples. Plane of vibration to be along three mutually perpendicular axes. The subject...

The leakage current from AC to safety ground will not exceed 3.5 mA-rms at 264Vac, 50 Hz. The subject power supplies will meet FCC class B requirements . The subject power supplies will meet FCC and CISPR 22 requirements . Label marking will be permanent, legible and complied with all agency requirements. 8.1. MODEL NUMBER LABEL Labels will be affixed to the sides of the power supply showing the following: - Manufacturer’s name and logo. - Model no., serial no., revision level, location of manufacturer. - The total power output and the maximum load for each output. 8.2 DC OUTPUT IDENTIFICATION...