video corpo

EC 450-1800sx
3Pages

{{requestButtons}}

Catalog excerpts

EC 450-1800sx - 1

Major Specifications Injection Unit Code Barrel Code Screw Diameter Injection Speed  (High speed) High Torque Shot Weight Clamping Force Distance Between Tie Rods (H×V) Clamp Stroke Machine Dimensions Note) 1. Due to continuous improvements, specifications are subject to change without notice. 2. Shot weight, Injection rate and plasticizing capacity are dependent upon molding conditions and resin used. 3. Max. injection pressure and max.holding pressure are power of injection unit, not resin pressure, Max. injection pressure and Max. holding pressure are limited according to molding conditions. 4. Values marked with *vary with optional T-slotted mold platen. 5. Values marked with **vary with optional insulating plates (10mm) are attached. 6. The figures of heater capacity are for 220V, those enclosed in ( ) are for 200V. 7. 1MPa=10.2kgf/㎝², 1kN=0.102tf © Copyright TOSHIBA MACHINE CO.,LTD All

Open the catalog to page 1
EC 450-1800sx - 2

Major Specifications ITEM Injection Unit Code Barrel Code Screw Diameter Shot Weight Injection Speed High Torque Clamping Force Distance Between Tie Rods (H×V) Clamp Stroke Machine Dimensions Note) 1. Due to continuous improvements, specifications are subject to change without notice. 2. Shot weight, Injection rate and plasticizing capacity are dependent upon molding conditions and resin used. 3. Max. injection pressure and max.holding pressure are power of injection unit, not resin pressure, Max. injection pressure and Max. holding pressure are limited according to molding conditions. 4....

Open the catalog to page 2
EC 450-1800sx - 3

Major Specifications ITEM Injection Unit Code Barrel Code Injection Speed Clamping Force Distance Between Tie Rods (H×V) Clamp Stroke Screw Diameter Shot Weight Machine Dimensions Note) 1. Due to continuous improvements, specifications are subject to change without notice. 2. Shot weight, Injection rate and plasticizing capacity are dependent upon molding conditions and resin used. 3. Max. injection pressure and max.holding pressure are power of injection unit, not resin pressure, Max. injection pressure and Max. holding pressure are limited according to molding conditions. 4. Values marked...

Open the catalog to page 3

All Shibaura Machine catalogs and technical brochures

  1. BTD-100.R12

    8 Pages

  2. EC 50-350s

    3 Pages

  3. ED2500

    1 Pages

  4. EC 30

    2 Pages

  5. EC-NII

    1 Pages

  6. EC5P

    1 Pages

  7. ED 650 850

    1 Pages

  8. EC5

    1 Pages

  9. IS DG DF

    1 Pages

  10. IS-GT

    1 Pages

  11. IS-GS

    1 Pages

  12. EC-P Ultra

    1 Pages