LM6093ACW LCD Module User Manual Release Date Prelimiay release Document Name: LM6093ACW-Manual-Rev0.1.doc Page: 1 of 14

LCD Module User Manual Document Name: LM6093ACW-Manual-Rev0.1.doc Page: 2 of 14

LCD Module User Manual Terminal Functions SDA_IN, serial input data. serial input clock (SCL). Negative Power Supply, Ground (0V) Positive Power Supply. CA1N Power DC/DC voltage converter. Connect a capacitor between CA1P and CA1N. CA1P XV0 Negative operating voltage of COM-drivers. V0 Positive operating voltage of COM-drivers. VG is the power of SEG-drivers. VG Reset signal. /RST = L, internal Initialization is executed. /RST = H, Normal running. Register Select A0 = H, Transferring the Display RAM data. A0 = L, Transferring the Instruction data. Chip select input pin. /CS=“L”: This chip is...

LCD Module User Manual Application circuit(example) 4.2 Adjusting the Display Contrast -- This LCD module equipped with latest digital contrast adjustment function. -- Its display contrast could be adjusted by MCU command. (Please see the command tables for details) -- It is recommended to provide a contrast adjustment interface for end-user, where the best display result could meet the individual preference in mass production. 4.3 Resetting the LCD module The LCD module should be initialized by setting /RST terminal at low level after the power supply stable. 4.4 Power off the LCD Module It...

TOPWAY 4.6 Page Address 0 1 LCD Module User Manual Column Address Internal Display RAM Address Note: Display start line = 0,INV = 0. Document Name: LM6093ACW-Manual-Rev0.1.doc Page: 8 of 14

LCD Module User Manual Display Data RAM (DDRAM) Document Name: LM6093ACW-Manual-Rev0.1.doc Page: 9 of 14

LCD Module User Manual Document Name: LM6093ACW-Manual-Rev0.1.doc Page: 10 of 14

LCD Module User Manual Document Name: LM6093ACW-Manual-Rev0.1.doc Page: 11 of 14

LCD Module User Manual Document Name: LM6093ACW-Manual-Rev0.1.doc Page: 12 of 14

LCD Module User Manual Note: *1. Do not use any other command not listed, or the system malfunction may result. *2. For the details of the Display Commands, please refer to ST75161 data sheet. Document Name: LM6093ACW-Manual-Rev0.1.doc Page: 13 of 14

LCD Module User Manual The LCD panel is made by glass. Any mechanical shock (eg. dropping form high place) will damage the LCD module. Do not add excessive force on the surface of the display, which may cause the Display color change abnormally. The polarizer on the LCD is easily get scratched. If possible, do not remove the LCD protective film until the last step of installation. Never attempt to disassemble or rework the LCD module. Only Clean the LCD with Isopropyl Alcohol or Ethyl Alcohol. Other solvents (eg. water) may damage the LCD. When mounting the LCD module, make sure that it is free...