CLASSIC Water Pump characteristic curve Functions Display in °C or °F Digital flow indicator Automatic temperature monitoring Self-optimising temperature controller 2 Heaters switchable in stages Display of system and supply pressure Pressure relief Automatic venting Automatic filling Mold draining with compressed air Leak-stop operation Construction Pump with mechanical seal Q (l/min) Water Performance specifications with water at 20 °C Fixed piping in stainless steel Heating elements made of Incoloy 800 Maintenance-free flow meter Cooling capacity Scale-free heat exchanger Indirect and direct cooling Unit on castors Safety devices Level control as dry-run protection 50 Mechanical safety thermostats Visual and acoustic fault indicators Integrated miniature circuit breakers Main switch, control transformer and motor protection switch Electronic temperature limiter ΔT (°C) Water Direct Cooling water flow rate: 25 l/min @ 10 °C, Heat transfer fluid flow rate: 35 l/min Fluid circuit diagram 7 1 1 2/2-way valve (normally closed), 2 Pilot valve for pneumatic 2/2-way valve, 3 Pump with reversible pumping direction, 4 Cooling coil, 5 Heating element, 6 Expansion vessel, 7 Compressed air supply, 8 Temperature sensor, 9 Flow sensor, 10 Pressure gauge, 11 Level sensor, 12 Safety thermostat, 13 Pressure relief valve, 14 Safety valve, 15 Check valve, 16 Filter Tool-Temp AG | Switzerland | tool-temp.ch

360 Maximum temperature Heating capacity Cooling capacity Pressure and flow rate Suction operation Rated motor power Control system Temperature measurement Pump pressure measurement Flow measurement (heat transfer fluid) Temperature sensor FeKo Type J Pressure gauge Vane wheel sensor with inductive pick-up Tool-Temp AG | Switzerland | tool-temp.ch