Torque sensor Type 0170/01 MS série Q .Range from 12 to 1000 Nm (106 in.lbs to 8850 in.lbs) .Precision: 0.2% capacity .Output signal +/- 5VDC .Rotation speed 12,000 rpm .Rotation angle measurement (option A) .Standard squarre male/female connection The torque sensor 0170 series is designed with a rotation shaft supported by bushings. The torque signal is transmitted from the rotating shaft via frequency modulation without contact. Technical specification Band pass kHz <= 3 Sensitivity creep on compensated range %/°C 0.015 Zero creep on compensated range %Em/°C 0.015 Linearity & hysteresis deviation % EM 0.2 Sealing Capacity IP 40 Nm +/- 12, 18, 50, 63, 100, 150, 160, 250, 300, 500, 1000 Output signal Vdc +/- 5 Safe overload %EM 150 Operating temperature °C +5 to +50 (40 to 120°F) Excitation voltage V 11 to 26 Rotating speed tours/min < 12000 Options Option A : angle measurement 2x360 pulse TTL 90° phase offset Wiring 12 pin male DIN connector for all 0170 series Prise A GND cran de calibration B +Mesure Angle 1 C +Mesure couple +/-5VDC D - Mesure couple E - Alimentation angle F + Alimentation couple G + Mesure angle 2 H + Alimentation angle JDétection plage de mesure (option) K Cran de calibration GND détection plage de mesure (option) L M GND boitier TECHNIQUES MODERNES D'EXTENSOMETRIE Parc d'activités de Signes - B.P. 734 - 83030 TOULON Cedex 9 Tel. 04.94.10.00.51 - Fax 04.94.10.00.52 Specifications are subject to change without notice Page 1