Vibration Isolation Systems Setup Guide, 2017 TableTop Platforms Vibration Isolation Systems Setup Guide, 2017 TableTop Platforms Introduction The 66 Series TableTops require a continuous supply of compressed air or Nitrogen to operate properly. For a complete discussion of the air supply requirements, see System Air Supply Requirements in introduction section of this document. Setup Instructions Tools Required: Utility knife, 6 inch scale Step 1 Carefully remove isolator from the inner carton and plastic bag. Note Save the carton for future transport. The inner carton contains four carefully positioned rigid foam pads and brackets which lock out the isolator when the carton is closed. Step 2 Place the isolator on a firm level surface. Step 3 Connect the air supply to the rear air inlet. TMC Ametek, Peabody, Massachusetts Page 1

Vibration Isolation Systems Setup Guide, 2017 TableTop Platforms Set air supply pressure to 20 psi. Wait approximately 2 minutes for the top plate to float. Place the instrument to be isolated on the top surface. Wait about 1 minute for top plate to settle. Level the plate at a height of 3/8 inch by turning each of three thumb wheels located on three sides as shown in figure below to adjust internal height adjusting valves. The plate travel range is from 3/16 inch to 9/16 inch. Height = 3/8” Thumb Wheel Figure 2, Height adjustments Increase Height: Move wheel to the right in a counter clockwise...

Vibration Isolation Systems Setup Guide, 2017 TMC-Ametek 15 Centennial Drive, Peabody MA 01960 USA Tel (800) 542-9725, (978) 532-6330 ■ Fax (978) 531-8682 [email protected] ■ [email protected] www.techmfg.com All data in this document is subject to change in accordance with TMC-Ametek policy of continual product improvement. Copyright © 2015 TMC-Ametek ■ All Rights Reserved All registered marks and trademarks are property of their respective holders.